101-500 practice question 3 of 30
During a system boot cycle, what program is executed after the BIOS completes its tasks?
Full set: 246 questionsThe system boot process follows a specific sequence. After the BIOS (Basic Input/Output System) or UEFI (Unified Extensible Firmware Interface) performs the Power-On Self-Test (POST) and initializes hardware, its final task is to locate and transfer control to the bootloader. The bootloader is a small program, typically located in the Master Boot Record (MBR) or an EFI System Partition (ESP), whose job is to load the Linux kernel into memory and execute it.
B. The inetd program: This is a network super-server daemon started much later in the boot process by the init system.
C. The init program: init (or systemd) is the first user-space process (PID 1) and is started by the kernel, which is after the bootloader.
D. The kernel: The kernel is loaded by the bootloader. Therefore, the bootloader must be executed first.
1. Red Hat Enterprise Linux 8 Installation Guide, Chapter 26. The boot process. Section 26.1. "The boot process". It explicitly states: "1. The system BIOS or UEFI initializes the hardware. 2. The BIOS or UEFI loads the boot loader from the MBR...".
2. The Linux Documentation Project (LDP), "Linux Boot Process" by Kim Oldfield. The document outlines the sequence as: BIOS -> MBR (Bootloader) -> GRUB (Bootloader) -> Kernel -> Init -> Runlevel.
3. MIT OpenCourseWare, 6.828 Operating System Engineering, Fall 2012, Lecture 3: The Boot Process. The lecture notes describe the PC boot sequence where the BIOS loads the boot sector (bootloader) from a disk.
Keep practicing
Take the free 101-500 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 101-500 practice questions
- Question 1Which of the following commands prints a list of available package updates when using RPM…
- Question 2Which of the following commands changes the number of days before the ext3 filesystem on …
- Question 4Which of the following commands reboots the system when using SysV init? (Choose TWO corr…
- Question 5Which of the following commands updates the linker cache of shared libraries?
- Question 6Which of the following commands can be used to create a USB storage media from a disk ima…
- Question 7Which of the following commands brings a system running SysV init into a state in which i…
