300-610 practice question 9 of 35
A large financial institution hosts all customer data in a critical data center with a single physical location Top management is concerned about the…
Full set: 277 questionsThe goal is to implement a cost-effective disaster recovery solution by extending Layer 2 connectivity between two data centers. Overlay Transport Virtualization (OTV) is a Cisco DCI technology specifically designed for this purpose. It encapsulates Layer 2 frames in IP packets to transport them across any IP network. The Cisco Nexus 7700 Series switches are high-performance data center platforms that fully support OTV, making them the ideal hardware to act as the OTV edge devices. This solution directly addresses the need for L2 extension and disaster recovery capabilities using the specified equipment.
A. Implement NVGRE on the Catalyst 8000 routers: NVGRE is a less common overlay than VXLAN, and Catalyst routers are typically WAN edge devices, not the primary DCI L2 extension platform.
C. Implement FabricPath on the Catalyst 8000 routers: FabricPath is a technology for building a loop-free, multipath Layer 2 fabric within a single data center, not for DCI.
D. Implement HSRP with the Nexus 7700 Series devices: HSRP provides first-hop gateway redundancy within a VLAN. It is not a DCI technology and does not extend connectivity between sites.
1. Cisco, "Cisco Nexus 7000 Series NX-OS OTV Configuration Guide," Configuration Guides. "Overlay Transport Virtualization (OTV) is an IP-based feature that provides Layer 2 extension capabilities over any transport IP network. OTV is a MAC-in-IP method that extends Layer 2 connectivity across a transport network." (Chapter: Information About OTV)
2. Cisco, "Cisco Nexus 7700 Platform Switches Data Sheet," Data Sheets. The data sheet lists "Overlay Transport Virtualization (OTV)" as a key supported software feature under the "Data Center Interconnect" section, confirming platform capability.
Keep practicing
Take the free 300-610 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 300-610 practice questions
- Question 3An architect must automate routine tasks within a data center The data center exclusively…
- Question 4A network consultant must design a high availability interconnection of a clustered Cisco…
- Question 5A Cisco engineer is developing a custom application that can run natively in Cisco NX-OS …
- Question 6Refer to the exhibit. Refer to the exhibit. An engineer is creating a new data center des…
- Question 7A small company hosts several critical applications on bare-metal servers connected via i…
- Question 8A network engineer needs to configure a high availability feature for a data center that …
