300-715 practice question 30 of 35

An engineer is configuring static SGT classification. Which configuration should be used when authentication is disabled and third-party switches are in use?

Full set: 294 questions
Answer options
A: VLAN to SGT mapping
B: IP Address to SGT mapping Correct answer
C: L3IF to SGT mapping
D: Subnet to SGT mapping
Correct Answer:
B. IP Address to SGT mapping
Explanation

When authentication is disabled (e.g., for servers, printers, or IoT devices) and the network includes third-party switches that are not TrustSec-capable, static classification must be performed on a central policy engine like Cisco ISE. The most appropriate method is IP Address to SGT mapping. ISE maintains a static table mapping specific IP addresses or subnets to Security Group Tags (SGTs). This IP-to-SGT binding information is then propagated via the Security Group Tag Exchange Protocol (SXP) to a TrustSec-capable enforcement point (like a firewall, router, or distribution switch), which can then enforce the security policy based on the SGT.

Why Incorrect

A. VLAN to SGT mapping: This method requires the network access device (NAD) to be TrustSec-capable to map all traffic from a specific VLAN to an SGT, which is not feasible with third-party switches.
C. L3IF to SGT mapping: This assigns an SGT to all traffic entering a specific Layer 3 interface on a NAD. This also requires a TrustSec-capable device, making it unsuitable for this scenario.
D. Subnet to SGT mapping: While you can map a subnet, this is a specific implementation of the broader "IP Address to SGT mapping" feature within ISE. The term "IP Address to SGT mapping" correctly encompasses both individual IPs and subnets.

References

1. Cisco Identity Services Engine Administrator Guide

Release 3.1 - "IP-SGT Static Mappings" section: "You can use the IP-SGT static mapping for endpoints that cannot be authenticated by any other means

for example

a server. Cisco ISE uses the IP address of the endpoint to map it to a specified SGT... You can enter a single IP address or a subnet for IP-SGT static mapping." This confirms that IP-to-SGT mapping is the designated feature for unauthenticated endpoints and can handle both single IPs and subnets.

2. Cisco TrustSec Platform and Capability

Cisco Press (2014) - Chapter 4

"TrustSec Classification

" Section "Static Classification": "IP address-to-SGT mapping is another form of static classification. This is useful for devices that do not support any form of authentication

such as servers

printers

and so on... The IP-to-SGT mapping is configured on the ISE

and ISE uses SXP to advertise the mapping to the rest of the TrustSec domain." This directly supports using IP-to-SGT mapping for devices that cannot be authenticated.

3. Cisco Live Presentation BRKSEC-3890 - "Advanced TrustSec Deployments" (2019) - Slide titled "Classification: IP to SGT Mapping": This presentation details use cases for IP-to-SGT mapping

including "Endpoints that cannot be authenticated" and "Non-TrustSec capable access." It explicitly states this method is for integrating devices on legacy or third-party switches into a TrustSec architecture.

Scroll to Top