ACE-A1-2 practice question 16 of 25
On what interface(s) will ZTP send out requests?
Full set: 127 questionsDomain Provisioning
When an Arista switch boots in Zero Touch Provisioning (ZTP) mode, it initiates a sequence to acquire an IP address and configuration details via DHCP. The process begins by sending a DHCP request out of the dedicated management interface. If this attempt is unsuccessful (e.g., no cable connected or no DHCP offer received), the switch will then systematically cycle through all connected front-panel Ethernet data interfaces, sending DHCP requests on each one until it receives a valid response. Therefore, the ZTP process can potentially use all connected interfaces to find a provisioning server.
A. ZTP starts with the management interface, but it is not the only interface used. If the initial attempt fails, it proceeds to use other connected ports.
B. The console is a serial port for direct, local command-line access and does not participate in network-based protocols like DHCP for ZTP.
C. ZTP only sends requests on interfaces with an active physical link (connected); it does not attempt to use all physical interfaces, including disconnected ones.
1. Arista EOS Configuration Guide 4.30.2F: In the "Zero Touch Provisioning (ZTP)" section, under "ZTP Operation," it states: "In ZTP mode, the switch initially attempts to use DHCP to obtain an IP address and other information for its management interface. If the DHCP attempt on the management interface fails, the switch cycles through all connected Ethernet data ports, attempting to use DHCP to obtain an IP address and provisioning information on each one." (Section: Zero Touch Provisioning (ZTP) > ZTP Operation).
Source: Arista Networks Official Documentation. Link to relevant section (Note: Direct link may change with version, but the content is consistent in ZTP documentation).
Keep practicing
Take the free ACE-A1-2 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other ACE-A1-2 practice questions
- Question 1How many Arista switches may be a part of a single MLAG domain?
- Question 2How many Virtual Network Identifiers are supported by the VXLAN specification?
- Question 3What is the name of the Arista EOS feature that allows you to set triggers and perform ac…
- Question 4What is required in order for Multi-Switch CLI to be implemented?
- Question 5Which of the following best describes Arista’s MLAG feature?
- Question 6Which of the following statements are true?
