You have added a compete interview clip onto a timeline. At the beginning of the dip. there are 10 seconds of material that you want to remove without leaving a gap. How can you achieve this?

The most efficient method to remove the beginning of a clip without leaving a gap is to use the "Ripple Trim Previous Edit to Playhead" command, which is mapped to the 'Q' key by default. By placing the playhead at the new desired start point (10 seconds into the clip), pressing 'Q' will trim away the material from the beginning of the clip to the playhead and automatically shift all subsequent clips on the timeline to close the gap. This single-keystroke action is specifically designed for this type of "top-and-tail" editing.

B: Using the Razor Tool to cut and then deleting the initial segment with the standard delete key would leave a gap, which violates the core requirement of the question. C: This method is functionally correct but less efficient. It requires two distinct steps: selecting the specific edit point and then pressing 'E'. The 'Q' key (Option A) accomplishes the same result with a single keystroke after positioning the playhead. D: Dragging the edge of a clip with the standard Selection Tool performs a regular trim, which does not ripple the timeline and would leave a 10-second gap.

1. Adobe Premiere Pro User Guide

"Trim clips in Adobe Premiere Pro":

Section: "Trim to the playhead using keyboard shortcuts": This section explicitly details the use of keyboard shortcuts for trimming. It states

"To perform a ripple trim

use the Ripple Trim Previous/Next Edit To Playhead commands." The 'Q' key is the default shortcut for "Ripple Trim Previous Edit To Playhead

" which trims the In point of a clip. This directly supports Answer A.

Section: "Make ripple edits and rolling edits": This section clarifies that a standard trim with the Selection tool (as described in option D) will leave a gap unless a modifier key is used or the dedicated Ripple Edit tool is selected.

Section: "Extend an edit": This section describes the functionality of the 'E' key (Option C)

confirming it as a valid

though multi-step

method for performing a ripple trim when an edit point is selected.