FCP_FAZ_AD-7-4 practice question 1 of 25
You finished registering a FortiGate device. After traffic starts to flow through FortiGate, you notice that only some of the logs expected are being received on FortiAnalyzer. What could be the reason for the logs not arriving on FortiAnalyzer?
Full set: 177 questionsThe most direct and common reason for receiving only a subset of expected logs from a FortiGate is an incomplete logging configuration on the FortiGate itself. FortiOS provides granular control over logging. An administrator must explicitly enable logging for individual firewall policies, security profiles (such as Antivirus, Web Filter, and IPS), and various system events. If logging is enabled for some policies or events but not others, FortiAnalyzer will only receive the logs that were configured to be sent, resulting in a partial log set.
A. FortiGate was added to the wrong ADOM type. An incorrect ADOM type primarily affects management capabilities and the availability of specific features in the FortiAnalyzer GUI, not the fundamental transport of logs from the FortiGate.
B. This FortiGate model is not fully supported. If a model were unsupported, it would likely fail to register correctly or send any logs at all, rather than sending only some logs.
D. This FortiGate is part of an HA cluster but it is the secondary device. While a secondary HA unit only sends its own system logs and not traffic logs, the question implies an expectation of logs from traffic flow. The root cause for missing expected traffic logs from the cluster as a whole would still be a configuration issue on the primary unit (Option C).
1. FortiOS 7.4 Administration Guide: In the "Firewall policies" section, it is detailed that for each policy, an administrator must enable the "Log Violation Traffic" option to record logs for traffic handled by that policy. This demonstrates the need for explicit configuration. (Reference: FortiOS Administration Guide 7.4, Chapter: "Firewall", Section: "Firewall policies").
2. FortiAnalyzer 7.4.2 Administration Guide: The troubleshooting section lists "The logging device is not configured to send logs to the FortiAnalyzer unit" as a primary reason for not receiving logs. This directly supports the idea that the source device's configuration is a critical factor. (Reference: FortiAnalyzer Administration Guide 7.4.2, Chapter: "Troubleshooting", Section: "Logs are not being received from a registered device").
3. FortiOS 7.4 High Availability Guide: The "HA logging" section explains that in an active-passive cluster, the primary unit is responsible for sending traffic logs. The secondary unit only sends logs about its own operation. This confirms that a configuration issue on the primary unit (Option C) would be the reason for missing traffic logs from the cluster. (Reference: FortiOS High Availability Guide 7.4, Chapter: "Introduction to HA", Section: "HA logging").
Keep practicing
Take the free FCP_FAZ_AD-7-4 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other FCP_FAZ_AD-7-4 practice questions
- Question 2Which two statements are true regarding the outbreak detection service? (Choose two.)
- Question 4For which two purposes would you use the command set log checksum? (Choose two.)
- Question 5What does the disk status Degraded mean for RAID management?
- Question 6What is required to authorize a FortiGate on FortiAnalyzer using Fabric authorization?
- Question 8What are offline logs on FortiAnalyzer?
- Question 9Which two elements are contained in a system backup created on FortiAnalyzer? (Choose two…
