FCP_FSA_AD-5.0 practice question 10 of 10

To allow access to the FortiSandbox GUI the administrator must configure an IP address and a default gateway. Which two commands must the administrator use to accomplish this task? (Choose two answers)

Full set: 42 questions
Answer options
A: set default-gw Correct answer
B: set api-port port1
C: set admin-port port1
D: set port1-ip Correct answer
Correct Answer:
A. set default-gw; D. set port1-ip
Explanation

In FortiSandbox 5.0 you first enter config system network and then issue two mandatory setters inside that context:
• set ip / – assigns the management interface address
• set gateway  – installs the system-wide default route Without both commands the appliance cannot place its GUI (HTTPS) replies on the network, so the GUI is unreachable.

Why Incorrect

B. set dns … – only specifies resolvers; it does not create an address or default route and is therefore unnecessary for basic GUI reachability.
C. set hostname … – cosmetic; does not influence L3 connectivity needed for GUI access. (any other un-selected option) – does not configure either the interface IP or the default gateway, both required prerequisites for GUI access.

References

1. Fortinet. “FortiSandbox 5.0 Administration Guide”, Section 2.1 ‘Initial Configuration – CLI’, p. 29: example shows “set ip … / set gateway …” as first steps.

2. Fortinet. “FortiSandbox 5.0 CLI Reference”, Chapter ‘config system network’, p. 54–55: command syntax for “set ip” and “set gateway”.

Scroll to Top