Which two CLI commands display the status of all switch interfaces? (Select two)

Both show interfaces brief and show interface status are valid ArubaOS-CX CLI commands used to display a summary of the operational state for all interfaces on a switch. The show interfaces brief command provides a concise table listing each interface along with its administrative and link status. Similarly, the show interface status command presents a summary table that includes the status (e.g., connected, notconnect), VLAN, duplex, speed, and type for every interface, fulfilling the requirement to view the status of all interfaces.

B. show ip route: This command is used to display the switch's IP routing table, which contains network routes, not the operational status of physical interfaces.
D. show vlan: This command displays information about configured VLANs and their port membership, but it does not show the link status (up/down) of the interfaces.

1. ArubaOS-CX 10.12 Command-Line Interface Guide

Hewlett Packard Enterprise Development LP

(December 2023).

Page 1619

show interfaces brief: "Shows a brief summary of interface configuration and status information." The command description and example output confirm it lists all interfaces and their status.

Page 1627

show interface status: "Shows the interface status for all interfaces." The command description and example output confirm it provides a summary table of status for all ports.

Page 1700

show ip route: "Shows the IP route table." This confirms the command's purpose is for routing information

not interface status.

Page 2110

show vlan: "Shows VLAN information." This confirms the command's purpose is for VLAN configuration

not interface link status.