II0-001 practice question 1 of 30

The following are components of an IP Datagram header except:

Full set: 229 questions
Answer options
A: Type of Service
B: Total Length
C: Header Checksum
D: Default Gateway address Correct answer
Correct Answer:
D. Default Gateway address
Explanation

The IPv4 datagram header contains several fields to facilitate the routing and delivery of packets. These include the Type of Service (ToS) for QoS, Total Length specifying the packet size, and a Header Checksum for error detection within the header. However, the Default Gateway address is not a field in the IP header. This address is part of a host's local routing table configuration and is used by the host's networking stack to forward packets to destinations outside the local network. The IP header itself only contains the source and destination IP addresses.

Why Incorrect

A. Type of Service is an 8-bit field in the IPv4 header used to indicate the desired quality of service for the datagram.
B. Total Length is a 16-bit field in the IPv4 header that defines the entire datagram size in bytes, including header and data.
C. Header Checksum is a 16-bit field in the IPv4 header used to check for corruption in the header itself.

References

1. Postel, J. (1981). RFC 791: Internet Protocol. IETF. Section 3.1, "Format". This document specifies the IPv4 header fields, which include Type of Service, Total Length, and Header Checksum, but not Default Gateway.

2. Fall, K. R., & Stevens, W. R. (2011). TCP/IP Illustrated, Volume 1: The Protocols (2nd ed.). Addison-Wesley Professional. Chapter 3, "IP: The Internet Protocol," details the IPv4 header structure.

3. Kurose, J. F., & Ross, K. W. (2017). Computer Networking: A Top-Down Approach (7th ed.). Pearson. Chapter 4, Section 4.4.1, "The IPv4 Datagram Format," provides a diagram and explanation of the header fields.

Scroll to Top