NCP-AII practice question 2 of 15
What command is needed to measure BER (Bit Error Rate)?
Full set: 71 questionsThe mlxlink utility in the Mellanox Firmware Tools (MFT) suite can initiate a built-in BER (Bit-Error-Rate) test against LinkX cables and transceivers, reporting the real-time error rate per lane.
A. ibdiagnet ― maps fabric topology and gathers port counters, but cannot run BER tests.
B. perfquery ― reads InfiniBand performance counters; BER is not calculated.
D. nvidia-smi ― manages GPU devices, no network-level BER capability.
1. NVIDIA Mellanox Firmware Tools User Manual v4.24, §15.2 “mlxlink – BER Test”, pp. 284-287.
2. “LinkX Cable Management”, NVIDIA Networking KB Article #5012, para. 3, 2023.
Keep practicing
Take the free NCP-AII practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other NCP-AII practice questions
- Question 1A system administrator noticed a failure on a DGX H100 server. After a reboot, only the B…
- Question 3During BCM cluster setup, an engineer must configure bonded network interfaces on DGX nod…
- Question 4What command sequence is used to identify the exact name of the server that runs as the m…
- Question 5A user wants to restrict a Docker container to use only GPUs 0 and 2. Which command achie…
- Question 6A team is validating a DGX BasePOD deployment. Using cmsh, they run a command to check GP…
- Question 7During a multi-day NeMo burn-in, intermittent "GPU fell off bus" errors occur. Which diag…
