NS0-161 practice question 5 of 15

What is the default RAID policy for aggregates created with 10 TB disk drives? (Choose the best answer)

Full set: 60 questions
Answer options
A:

A. RAID4

B:

B. RAID-DP

C:

C. RAID0

D:

D. RAID-TEC

Correct answer
Correct Answer:
D. D. RAID-TEC
Explanation

NetApp ONTAP automatically selects a default RAID policy during aggregate creation based on the drive type and capacity to ensure an appropriate level of data protection. For aggregates built with high-capacity Hard Disk Drives (HDDs) of 6 TB or greater, ONTAP defaults to RAID-TEC (Triple-Parity RAID). This policy protects against up to three simultaneous drive failures, mitigating the increased risk associated with the longer rebuild times of large drives. Since the question specifies 10 TB drives, which exceed the 6 TB threshold, RAID-TEC is the default policy.

Why Incorrect

A. RAID4: This is incorrect. RAID4 is the default policy only for root aggregates, not for data aggregates using large-capacity drives.
B. RAID-DP: This is incorrect. RAID-DP (Dual-Parity RAID) is the default for data aggregates using HDDs smaller than 6 TB or for all SSDs.
C. RAID0: This is incorrect. RAID0 provides no data protection (parity) and is not a default RAID policy for ONTAP data aggregates.

References

1. NetApp ONTAP 9 Documentation, Logical Storage Management, "RAID policies for data aggregates": "RAID-TEC is the default policy for aggregates that are created by using HDDs with a capacity of 6 TB or greater. RAID-DP is the default policy for all other aggregates (except for the root aggregate), including aggregates that are created by using SSDs of any capacity or HDDs with a capacity of less than 6 TB."

2. NetApp Technical Report 4090, "RAID-TEC and Mirrored Aggregate Implementation Guide", Page 5, Section "When to Use RAID-TEC": "Beginning with ONTAP 9, RAID-TEC is the default RAID type for data aggregates that are created with hard disk drives (HDDs) that are 6TB or larger in capacity."

Scroll to Top