NSE5_FNC_AD_7-6 practice question 3 of 10

When configuring isolation networks in the configuration wizard, why does a layer 3 network typo allow for mora than ono DHCP scope for each isolation network typo?

Full set: 32 questions
Answer options
A: The layer 3 network type allows for one scope for each possible host status. Correct answer
B: Configuring more than one DHCP scope allows for DHCP server redundancy
C: There can be more than one isolation network of each type
D: Any scopes beyond the first scope are used if the initial scope runs out of IP addresses.
Correct Answer:
A. The layer 3 network type allows for one scope for each possible host status.
Explanation

Layer 3 isolation networks in FortiNAC can span multiple physical subnets. The ability to configure multiple DHCP scopes for a single L3 isolation network type allows administrators to assign different IP configurations based on the host's status. For example, a device needing registration can be assigned an IP from one scope with limited access, while a non-compliant device needing remediation can be assigned an IP from another scope with access only to remediation servers.

Why Incorrect

B. DHCP server redundancy is managed at the DHCP server level (for example, using failover configurations), not by defining multiple scopes within FortiNAC for this purpose.
C. While multiple isolation networks can exist, this option does not explain why a single L3 network type supports multiple DHCP scopes.
D. Using subsequent scopes when one is exhausted is a function of a DHCP superscope, not the primary reason FortiNAC allows multiple scopes for isolation networks.

References

1. Fortinet NSE Training Institute. (2022). NSE 5 FortiNAC 7.2 Study Guide. Page 51, "Isolation Networks". "For layer 3 isolation networks, you can configure multiple DHCP scopes. This allows you to configure a different scope for each host state, such as registration and remediation."

2. Fortinet Document Library. (2023). FortiNAC 7.4.0 Administration Guide. Page 101, "Isolation Networks". "For Layer 3 networks, you can configure multiple DHCP scopes. This allows you to configure a different scope for each host state, such as registration and remediation."

Scroll to Top