NSE7_FSN_AR-7.6 practice question 10 of 10

Your enterprise network uses IPsec tunnels for redundancy. Two hub sites in different regions are connected via IPsec to 50 branch offices. You observe that branches experience 200ms latency variance when failing over between hubs, and some sessions drop during convergence. Which combination of technologies should you implement to optimize hub failover and reduce convergence time?

Full set: 163 questions
Answer options
A:

A. BGP route reflectors, Bidirectional Forwarding Detection (BFD), graceful-restart, and IPsec aggregate for redundancy

Correct answer
B:

B. OSPF equal-cost multi-path (ECMP) with MaxAge timers and VDOM partitioning

C:

C. FortiGate Clustering Protocol (FGCP) with active-active load balancing and virtual MAC addresses

D:

D.Multiple BGP neighbor groups with longer hold-times and increased hello intervals

Correct Answer:
A. A. BGP route reflectors, Bidirectional Forwarding Detection (BFD), graceful-restart, and IPsec aggregate for redundancy
Explanation

To optimize failover and minimize convergence time in a dual-hub IPsec VPN topology, Bidirectional Forwarding Detection (BFD) is critical as it provides sub-second failure detection for routing protocols like BGP, significantly outperforming standard protocol timers. BGP route reflectors are ideal for scaling hub-and-spoke routing architectures. Graceful-restart ensures that the data plane continues forwarding packets while the control plane recovers, preventing session drops. Finally, configuring an IPsec aggregate interface allows multiple IPsec tunnels to be bundled into a single logical interface, providing seamless redundancy, load balancing, and faster failover without waiting for routing protocol reconvergence.

Why Incorrect

B: OSPF MaxAge timers are used for flushing Link-State Advertisements (LSAs), not for rapid failure detection; BFD is the industry standard for fast convergence. C: FortiGate Clustering Protocol (FGCP) is designed for local High Availability (HA) within the same physical site, not for failover between geographically dispersed hub sites. D: Increasing BGP hello intervals and hold-times would delay failure detection, thereby increasing convergence time rather than reducing it.

References

Fortinet NSE 7 Enterprise Firewall 7.x Study Guide, Chapter: Routing and IPsec VPN, Sections: BFD and IPsec Aggregation.

RFC 5880 (Bidirectional Forwarding Detection), Section 2 (Design Goals). https://doi.org/10.17487/RFC5880

Keep practicing

Take the free NSE7_FSN_AR-7.6 practice test

Ten exam-style questions with answers and explanations, plus the exam facts and study guides.

Start the free practice test

More questions

Other NSE7_FSN_AR-7.6 practice questions

Scroll to Top