NSE7_SDW-7-2 practice question 15 of 15

Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)

Full set: 99 questions
Answer options
A: The session information output displays no SD-WAN-specific details. Correct answer
B: All SD-WAN rules have the default and gateway setting enabled.
C: Traffic does not match any of the entries in the policy route table. Correct answer
D: Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
Correct Answer:
A. The session information output displays no SD-WAN-specific details.; C. Traffic does not match any of the entries in the policy route table.
Explanation

When network traffic does not match any explicitly configured SD-WAN rules, it is processed by the implicit SD-WAN rule (ID 0). The function of this rule is to hand the traffic over to the standard FortiOS routing engine. Consequently, because the SD-WAN engine is not used for path selection, the session details will not contain any SD-WAN-specific information (A). The standard routing process first checks for a match in the policy route table. If no policy route matches, it then performs a lookup in the main routing table (FIB). Therefore, for traffic to be routed by the FIB after matching the implicit SD-WAN rule, it must also not have matched any policy routes (C).

Why Incorrect

B. The default and gateway settings are specific options for an explicit SD-WAN rule to function as a default route, not a property of the implicit rule.
D. ECMP load balancing (v4-ecmp-mode) is only used if the final FIB lookup results in multiple equal-cost paths; it is not a guaranteed outcome for all traffic matching the implicit rule.

References

1. FortiOS Administration Guide 7.0.1 > Routing > Packet flow and session creation: The packet flow diagram illustrates the order of operations where traffic is checked against SD-WAN rules first. If there is no match (i.e., it hits the implicit rule), it is then checked against Policy Routes, and finally, the Forwarding Information Base (FIB). This supports the logic for option C.

2. FortiOS Administration Guide 7.0.1 > SD-WAN > SD-WAN rules: "An implicit rule is at the bottom of the rule list that catches all traffic that is not matched by any of the rules in the list. The implicit rule forwards traffic to the routing table to be routed based on the routes in the table." This confirms that traffic is passed to the standard routing engine, bypassing SD-WAN member selection logic, which supports option A.

3. Fortinet NSE 7—SD-WAN 7.0 Study Guide, page 18 (FortiGate SD-WAN—Routing and Sessions): "If traffic doesn't match any SD-WAN rule, it matches the implicit SD-WAN rule. The implicit SD-WAN rule instructs FortiGate to look up the destination IP address in the routing table." This confirms the handover to the standard routing process.

4. FortiOS CLI Reference 7.0.1 > diagnose sys session list: The command output for a session processed by an explicit SD-WAN rule includes fields like sdwanserviceid. The absence of these fields indicates the session was not handled by the SD-WAN engine, which is the case for the implicit rule, supporting option A.

Scroll to Top