PCNSE practice question 34 of 35

An engineer is monitoring an active/active high availability (HA) firewall pair. Which HA firewall state describes the firewall that is currently processing traffic?

Full set: 377 questions

Domain Configure and Troubleshoot

Answer options
A: Initial
B: Passive
C: Active
D: Active-primary Correct answer
Correct Answer:
D. Active-primary
Explanation

In an Active/Active HA pair, both peers forward traffic, but each takes one of two explicit states—Active-primary or Active-secondary. The state “Active-primary” is defined by Palo Alto Networks as “the firewall that is actively processing traffic and acts as the session owner” in an Active/Active deployment. The generic state “Active” is used only for Active/Passive HA and is not reported by devices running in Active/Active mode. Therefore, the precise state that identifies a traffic-processing firewall in the stated scenario is Active-primary.

Why Incorrect

A. Initial – Device is booting or negotiating HA; no traffic is processed.
B. Passive – Exists only in Active/Passive HA; firewall does not forward traffic.
C. Active – Valid only for Active/Passive; not a state shown on an Active/Active pair.

References

1. Palo Alto Networks, PAN-OS 11.0 Administrator’s Guide, “HA Firewall States,” Table-1: Active-primary—“Device actively processes traffic (session owner) in Active/Active HA.” (Doc ID: PAN-OS-AG-11.0, p. 920).

2. Palo Alto Networks TechDocs, “Set Up Active/Active HA,” section “Active-primary and Active-secondary states,” ¶2 (2023).

Scroll to Top