VNX301 practice question 2 of 10

You are troubleshooting a branch that cannot form SD-WAN overlay tunnels. The branch has WAN interfaces up, but you suspect remote endpoint objects were not learned. Which VSM command should you use to verify whether remote site objects were learned from BGP or from configuration?

Full set: 60 questions
Answer options
A: show vsm p2mp tunnel-remote-endpoint tenant Correct answer
B: show interfaces brief
C: show system storage
D: show orgs org-services cgnat summary
Correct Answer:
A. show vsm p2mp tunnel-remote-endpoint tenant
Explanation

The show vsm p2mp tunnel-remote-endpoint command is executed on the Versa Controller to display the remote site information learned for SD-WAN overlay tunnels. This command's output shows the remote endpoint's IP address, the site ID, and the source from which this information was learned (e.g., BGP or static configuration). This directly addresses the need to verify if the Controller has successfully learned the necessary remote endpoint objects required for a branch to establish its overlay tunnels. Without this information on the Controller, the branch will not receive the required control plane messages to build tunnels to other sites.

Why Incorrect

B. show interfaces brief: This command displays the status of local physical and logical interfaces on a device, not the SD-WAN control plane state for remote sites.
C. show system storage: This command shows disk partition usage and storage information, which is unrelated to SD-WAN tunnel formation or control plane learning.
D. show orgs org-services cgnat summary: This command is used for troubleshooting Carrier-Grade NAT services and has no relevance to learning SD-WAN remote endpoints.

References

Versa Networks, "VOS™ CLI Reference Guide, Release 21.2.2", Page 1188. The guide details the show vsm p2mp tunnel-remote-endpoint command, specifying its use for displaying P2MP tunnel remote endpoint information learned by the VSM daemon.

Scroll to Top