301A practice question 1 of 25
An application is expected to maintain more than 100,000 concurrent TCP connections to a single pool member. What is an appropriate SNAT configuration in this situation?
Full set: 147 questionsA single IP address is limited to approximately 65,535 ephemeral ports. When the BIG-IP system performs SNAT for connections to the same destination IP address and port, each new connection consumes an available port on the SNAT translation address. To support more than 100,000 concurrent connections, which exceeds the capacity of a single IP, multiple translation addresses are required to prevent port exhaustion. A SNAT pool configured with multiple IP addresses (four, in this case) provides the necessary port capacity, allowing the system to scale and handle the high connection load.
B. SNAT automap enabled: This option typically uses a single self-IP address for translation, which would be insufficient and lead to port exhaustion under this connection load.
C. A static SNAT: This is not a standard F5 term for a many-to-one translation scenario. A standard NAT object implies a one-to-one mapping, which is inappropriate here.
D. A SNAT pool with IP address: This vague option implies a SNAT pool with a single IP address, which does not solve the fundamental port exhaustion problem.
1. F5 Knowledge Base, K7820: Overview of SNAT features. In the "SNAT pool" section, it states: "A SNAT pool should be used when you want to allow more than 64,000 concurrent connections to the same destination IP address." This directly addresses the scenario of exceeding the port capacity of a single translation address.
2. F5 Knowledge Base, K14904: The BIG-IP system may be unable to establish new connections after a SNAT port is exhausted. The "Recommended Actions" section explicitly advises: "To allow for more connections, you can configure a SNAT pool with multiple IP addresses." This confirms that a SNAT pool is the correct solution for port exhaustion.
3. F5 BIG-IP LTM Implementations Guide (v16.1), Chapter: Configuring SNATs, Section: About SNATs. The documentation describes a SNAT pool as a "group of translation addresses" used for a "one-to-many" configuration, which is the mechanism designed to scale source address translation beyond a single IP address.
Keep practicing
Take the free 301A practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 301A practice questions
- Question 2A virtual server is using a TCP profile based on the top-wan-optimized profile for a stre…
- Question 4An LTM Specialist needs to gather website statistics such as latency and throughput on th…
- Question 5An LTM Specialist is configuring a virtual server with an IP address. Which configuration…
- Question 7An TLM Specialist needs to configure a virtual server to terminate SSL connection on the …
- Question 9A LTM device needs to load balance active and passive FTP traffic while using only a sing…
- Question 11An LTM device configured with a management IP address and route and a series of self-IPs …
