CTSC practice question 25 of 25

What is an acceptable quality level (AQL) in the context of sampling inspection?

Full set: 151 questions
Answer options
A: The average quality level of a satisfactory process
B: The minimum allowable number of defects in a sample
C: The minimum acceptable level of product quality
D: The limit of defective units acceptable in a continuing series of lots Correct answer
Correct Answer:
D. The limit of defective units acceptable in a continuing series of lots
Explanation

The Acceptable Quality Level (AQL) is a fundamental concept in statistical quality control and acceptance sampling. It is defined as the maximum percent defective (or maximum number of defects per hundred units) that, for purposes of sampling inspection, can be considered satisfactory as a process average for a continuing series of lots. AQL is not a guarantee that any single lot will have a certain quality, nor is it a target for individual products. Instead, it is a statistical threshold for the manufacturing process average, used to define the sampling plan's risk profile.

Why Incorrect

A. The average quality level of a satisfactory process: This is imprecise. AQL is not just any average; it is the worst tolerable process average or the limit.
B. The minimum allowable number of defects in a sample: This describes the "acceptance number" (Ac), which is a component of a sampling plan derived from the AQL, but it is not the AQL itself.
C. The minimum acceptable level of product quality: This is too general. AQL is a specific statistical measure applied to a process average over multiple lots, not an individual product's quality level.

References

1. International Organization for Standardization. (1999). ISO 2859-1:1999 Sampling procedures for inspection by attributes — Part 1: Sampling schemes indexed by acceptance quality limit (AQL) for lot-by-lot inspection. (Section 3.1.26 defines AQL as "quality level that is the worst tolerable process average").

2. Montgomery, D. C. (2013). Introduction to Statistical Quality Control (7th ed.). John Wiley & Sons. (Chapter 15, "Lot-by-Lot Acceptance Sampling by Attributes," defines AQL as the "poorest level of quality for the supplier's process that the consumer would consider to be acceptable as a process average").

3. American National Standards Institute / American Society for Quality. (2018). ANSI/ASQ Z1.4-2008 (R2018): Sampling Procedures and Tables for Inspection by Attributes. (This standard, which is the U.S. equivalent of ISO 2859-1, provides the same definition and operational use of AQL).

Scroll to Top