HPE2-T37 practice question 20 of 25

You try to add an HPE Primera array to HPE OneView, but you get a connectivity error. However, you can connect to the array using SSMC. What should you verify before adding HPE Primera to HPE OneView?

Full set: 115 questions
Answer options
A: whether WSAPI service is enabled on HPE Primera array. Correct answer
B: whether the appropriate license for HPE Primera Is available in HPE OneView.
C: whether array management using HPE OneView is enabled in SSMC.
D: whether there are at least two Fibre Channel networks defined in HPE OneView.
Correct Answer:
A. whether WSAPI service is enabled on HPE Primera array.
Explanation

HPE OneView communicates with HPE Primera through the array’s Web Services API (WSAPI). If WSAPI is disabled, OneView cannot establish a session and reports a connectivity error. SSMC, however, can still reach the array by tunnelling through the Service Processor, so its success does not prove that WSAPI is active. Therefore, the first step is to verify—-and, if necessary, enable—-the WSAPI service on the Primera array before attempting to add it to HPE OneView again.

Why Incorrect

B. OneView licences are host-based; no separate licence is required to register a storage system.
C. SSMC has no setting that “enables OneView management”; it only manages arrays itself.
D. FC networks are needed for volume provisioning, not for initial array registration/management.

References

1. HPE OneView 6.1 User Guide, “Adding storage systems”, p. 335 (R0Q87-96501, Jul 2021): “Ensure the WSAPI service is enabled on an HPE Primera or 3PAR system before adding it.”

2. HPE Primera OS CLI Reference, “setwsapi / showwsapi” commands, pp. 674-678 (R0Q88-98014, Dec 2020): describes enabling and verifying WSAPI.

3. HPE 3PAR StoreServ Management Console 3.7 Administrator Guide, p. 18 (Q1J61-96015, 2021): notes SSMC can connect via Service Processor even when array WSAPI is disabled.

Scroll to Top