HPE2-T37 practice question 9 of 25
Your customer asks you if it is possible to perform HPE Synergy initial setup remotely. How should you respond?
Full set: 115 questionsThe initial setup of an HPE Synergy frame can be performed remotely. This process requires a DHCP server to be available on the management network. When the Synergy frame is powered on for the first time, the HPE Composer 2 and Frame Link Modules (FLMs) will automatically request and receive IP addresses from the DHCP server. An administrator can then identify the IP address assigned to the active Composer and connect to it using a web browser from a remote workstation on the same network to complete the guided setup wizard.
B: Remote setup is a standard, built-in technical capability of HPE Synergy and does not require the purchase of additional services. C: This is incorrect. While local console setup is a valid method, it is not the only one; remote setup via DHCP is also a fully supported procedure. D: The primary management interface for configuration is the HPE Composer, not the Frame Link Module (FLM), and this remote capability is standard, not a special factory-enabled option.
1. HPE Synergy Configuration and Installation Guide (Part Number: 853492-013, November 2022):
Page 28, Chapter 3: Initial hardware setup, Section: "Completing the hardware setup": This section explicitly states, "You can complete the hardware setup by using a local console or by using a remote computer."
Page 29, Section: "Completing the hardware setup using a remote computer": This section details the prerequisites, stating, "A DHCP server is available on the management network." It then describes the procedure: "When the HPE Synergy frame is powered on for the first time, the HPE Synergy Composers and Frame Link Modules automatically obtain IP addresses from the DHCP server... Open a web browser and enter the IP address of the active HPE Synergy Composer." This directly supports answer A and refutes C and D.
2. HPE OneView 8.2 for HPE Synergy Installation Guide (Part Number: P11103-012, October 2023):
Page 14, Chapter 2: Installing the appliance, Section: "Hardware setup overview": The guide outlines the two methods for initial setup: "You can complete the hardware setup by using a local console or by using a remote computer." This confirms that remote setup is a standard, documented procedure. The guide's subsequent sections detail the DHCP requirement for the remote method, reinforcing the correctness of option A.
Keep practicing
Take the free HPE2-T37 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other HPE2-T37 practice questions
- Question 1How can your customer obtain the PowerShell Library for HPE OneView?
- Question 2Your customer built a sever profile for HPE Synergy Gen 10 server and configured boot mod…
- Question 4How will setting the Purpose field within the network definition of a server profile impa…
- Question 5You want to add the latest IL0 firmware to an HPE OneView firmware repository. How can yo…
- Question 6Which components require an HPE OneView license for management?
- Question 7Which statement about a Logical Enclosure for HPE BladeSystem is Hue?
