HPE3-U01 practice question 8 of 10
You have connected a Multilayer switch to an Internet Service Provider router that has the 172.16.31.254 IP address. What configuration line do you have to enter on your switch to enable internet access?
Full set: 60 questionsTo enable a device on a local network to access the internet, a default route must be configured. This route directs all traffic for which the switch does not have a more specific route to a next-hop gateway, which in this case is the ISP router. The command ip route 0.0.0.0/0 172.16.31.254 configures a static default route. The 0.0.0.0/0 prefix represents any destination network, and 172.16.31.254 is the IP address of the ISP router that will forward the traffic to the internet. This is the standard syntax for modern network operating systems like ArubaOS-CX.
A. This option uses incorrect command syntax and parameter order for an Aruba switch.
C. The routing command is not used for this purpose, and a subnet mask should not be applied to the next-hop gateway address.
D. The ip routing command is used to enable the routing function globally on the switch, not to configure a specific static route.
1. Aruba. (2021). ArubaOS-CX 10.07 Fundamentals Guide. Chapter: "Static Routing," Page 2. The guide specifies the command syntax for configuring static routes as ip route . For a default route, DEST-PREFIX is 0.0.0.0/0.
2. Aruba. (2021). Aruba Certified Network Technician (ACNT) Study Guide. Module 4: IP Routing. This section details the configuration of static and default routes on Aruba switches.
Keep practicing
Take the free HPE3-U01 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other HPE3-U01 practice questions
- Question 1You connect a computer to the network. Assuming you have configured a static address to i…
- Question 2How many IP assignable addresses are contained in 10.0.128.0/23?
- Question 3On which connection type are collisions more likely to happen?
- Question 4What is a characteristic of IPv4 addresses?
- Question 6Which commands can you use to save the switch configuration changes, so they survive a sw…
- Question 7Which statement accurately describes an omnidirectional antenna?
