NIOS-DDI-EXPERT practice question 13 of 15

VRRP is used for Infoblox High Availability. VRRP requires a virtual IP address, a virtual router ID, a virtual MAC address, and a VRRP priority. The administrator configures which values? (Select all that apply.)

Full set: 80 questions
Answer options
A: Virtual MAC address
B: Virtual IP address Correct answer
C: Virtual router ID Correct answer
D: VRRP priority
Correct Answer:
B. Virtual IP address; C. Virtual router ID
Explanation

When configuring an Infoblox High Availability (HA) pair using VRRP, the administrator is required to define specific parameters for the virtual router instance. The administrator must configure the Virtual IP (VIP) address, which serves as the single, resilient service address for the HA pair. Additionally, the administrator must specify a unique Virtual Router ID (VRID) on the network segment to distinguish this HA pair's VRRP group from others. The Virtual MAC address is not configured; it is automatically derived from the VRID. Similarly, the VRRP priorities are automatically assigned by the NIOS software (255 for the active node, 250 for the passive node) and are not user-configurable.

Why Incorrect

A. Virtual MAC address: This value is automatically generated by the system based on the configured Virtual Router ID (VRID), following the IANA standard format 00-00-5E-00-01-{VRID}. It is not a user-configurable field.
D. VRRP priority: NIOS automatically assigns fixed priority values to the HA nodes to manage the master/backup roles. The active node is assigned a priority of 255, and the passive node is assigned 250. These values cannot be modified by the administrator.

References

1. Infoblox NIOS 9.0.0 Administrator Guide, Page 818, "Configuring an HA Pair".

This section explicitly details the configuration steps: "In the HA Pair Properties editor, complete the following: Virtual Router ID: Enter a VRID (Virtual Router ID) from 1 to 255... Virtual IP Address: Enter the IPv4 address that you want to use as the VIP for the HA pair." This directly supports that options B and C are configured by the administrator.

2. Infoblox NIOS 9.0.0 Administrator Guide, Page 816, "About HA Pairs".

This section states: "The active node in an HA pair has a VRRP priority of 255. The passive node has a VRRP priority of 250. You cannot change these values." This confirms that option D is incorrect.

3. IETF RFC 3768, Virtual Router Redundancy Protocol (VRRP), Section 7.3, "Virtual Router MAC Address".

This official standard specifies the derivation of the virtual MAC address: "The virtual router MAC address associated with a virtual router is an IEEE 802 MAC Address in the following format: 00-00-5E-00-01-{VRID} (in hex)." This confirms that the Virtual MAC address (Option A) is derived, not configured.

Scroll to Top