NS0-161 practice question 12 of 15
Your company has recently decided to stop using the Fibre Channel Protocol (FCP) in the data center. You are asked to decommission FCP and reuse any UTA2 ports to 10 GbE. Which two steps are involved in this task? (Choose two.)
Full set: 60 questionsRepurposing a Unified Target Adapter 2 (UTA2) port from Fibre Channel (FC) to 10 GbE involves two primary steps. First, any logical configuration dependent on the current port personality must be removed. This requires destroying any FC logical interfaces (LIFs) that are hosted on the physical ports being converted. Second, after the LIFs are removed and the port personality is changed using the system node hardware unified-connect modify command, the change only takes effect after the node is rebooted. The reboot allows the system to re-initialize the hardware with its new Ethernet personality.
C. Remove the FCP license from all nodes in the cluster. Removing the FCP license is an administrative cleanup action, not a technical prerequisite for changing a port's hardware personality. The port can be reconfigured while the license remains installed.
D. License additional ports for 10 GbE connectivity. UTA2 ports are inherently capable of 10 GbE connectivity. Changing the personality from FC to Ethernet does not require a new or additional license for the port's basic network functionality.
1. NetApp Technical Report 4375, "NetApp Unified Target Adapter 2 (UTA2) and Onboard Ports":
Page 10, Section 3.1, "Changing Port Personalities": "Before changing the personality of a port, all logical interfaces (LIFs) must be removed from the port." This directly supports answer B.
Page 10, Section 3.1, "Changing Port Personalities": "After the port personality has been changed, the node must be rebooted for the change to take effect." This directly supports answer A.
2. ONTAP 9 Commands: Manual Page Reference, system node hardware unified-connect modify:
Description: "This command modifies the adapter type and mode of a UTA port... After you run this command, you must reboot the node for the changes to take effect." This confirms that a reboot is a mandatory step, supporting answer A.
3. ONTAP 9.7 Physical Storage Management Guide, "Configure UTA2 ports":
Page 25, "Step 3": "If any LIFs are hosted on the port, migrate or destroy them... You cannot change the personality of a port if it is hosting LIFs." This confirms the requirement to remove LIFs, supporting answer B.
Keep practicing
Take the free NS0-161 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other NS0-161 practice questions
- Question 1What are three types of licenses available for ONTAP? (Choose three.)
- Question 3You are setting up replication between two clusters. In this scenario, which two componen…
- Question 5What is the default RAID policy for aggregates created with 10 TB disk drives? (Choose th…
- Question 6You are asked to investigate possible solutions for increasing the performance of a read-…
- Question 7You are asked to create a new SVM to serve SMB data using Active Directory authentication…
- Question 8When deploying NVMe/FC, what must be supported and enabled on the host to ensure proper m…
