PSP practice question 29 of 35

Microwave sensors work best on targets moving through the detection zone:

Full set: 312 questions

Domain Implementation of Physical Security Measures

Answer options
A: Laterally in relation to the sensor
B: At high speed
C: Toward or away from the sensor Correct answer
D: At low speed
Correct Answer:
C. Toward or away from the sensor
Explanation

Microwave sensors operate based on the Doppler effect, which detects a change in the frequency of a reflected wave caused by a target's motion relative to the sensor. This frequency shift is maximized when the target moves directly toward or away from the sensor, a path known as radial movement. This motion causes the greatest rate of change in the distance between the sensor and the target, producing a strong, detectable signal. Conversely, movement that is perpendicular or tangential to the sensor's beam results in a minimal change in distance and, therefore, a negligible Doppler shift, making detection unreliable.

Why Incorrect

A: Lateral (tangential) movement produces the weakest Doppler shift, making it the most difficult motion for a microwave sensor to reliably detect. B: While high speed increases the magnitude of the Doppler shift, the direction of movement (radial) is the fundamental requirement for detection. D: Very low speeds may be intentionally filtered out by the sensor's signal processing to prevent nuisance alarms from environmental factors.

References

1. Garcia

M. L. (2008). The Design and Evaluation of Physical Protection Systems (2nd ed.). Butterworth-Heinemann. In Chapter 7

Section 7.3.2

"Microwave Sensors

" it is stated: "The Doppler shift is proportional to the velocity of the intruder in a direction toward or away from the sensor (radial velocity). An intruder moving across the beam (tangential velocity) will not be detected."

2. ASIS International. (2021). Protection of Assets: Physical Security. Tysons

VA: ASIS International. The chapter on "Intrusion Detection and Assessment" explains that volumetric sensors like microwave detectors are most sensitive to motion that is radial to the unit (i.e.

directly approaching or receding from it) due to their reliance on the Doppler principle.

3. P. A. Belanger. (1988). Doppler effect and the concept of wave-trains. American Journal of Physics

56(6)

543-544. https://doi.org/10.1119/1.15510. This academic paper explains the underlying physics of the Doppler effect

confirming that the frequency shift is dependent on the component of the source's velocity along the line connecting the source and the observer (radial velocity).

Scroll to Top