300-730 practice question 3 of 25

A user is experiencing delays on audio calls over a Cisco AnyConnect VPN. Which implementation step resolves this issue?

Full set: 175 questions
Answer options
A: Change to 3DES Encryption.
B: Shorten the encryption key lifetime.
C: Install the Cisco AnyConnect 2.3 client for the user to download.
D: Enable DTLS. Correct answer
Correct Answer:
D. Enable DTLS.
Explanation

Cisco AnyConnect VPN can use both TLS (which runs over TCP) and DTLS (which runs over UDP). For latency-sensitive applications like voice and video, TCP's overhead for acknowledgments and retransmissions can introduce delays and jitter. Enabling DTLS allows the AnyConnect client to establish a parallel UDP-based tunnel. The ASA then sends delay-sensitive traffic, such as audio calls, over the DTLS tunnel, which avoids TCP's overhead and provides better performance for real-time applications. This directly addresses the user's issue with audio call delays.

Why Incorrect

A. 3DES is a legacy encryption algorithm that is computationally more intensive and slower than modern standards like AES, which would worsen performance.
B. Shortening the key lifetime forces more frequent re-keying, which could cause minor interruptions but does not solve persistent latency or delay issues.
C. Cisco AnyConnect 2.3 is an extremely old, end-of-life version. Modern versions offer significant performance and security improvements.

References

1. Cisco, Cisco AnyConnect Secure Mobility Client Administrator Guide, Release 4.10, "About VPN Connections", Section: "TLS, and DTLS". It states, "DTLS is a protocol that provides security for datagram-based applications by allowing them to communicate in a way that is designed to prevent eavesdropping, tampering, or message forgery. DTLS is included in the base AnyConnect license. It provides an optimized connection for TCP-based applications and is used by applications that are sensitive to delay, such as VoIP or TCP-based applications."

2. Cisco, Cisco ASA Series VPN CLI Configuration Guide, 9.12, "Configure AnyConnect Connections", Section: "Enable DTLS". The documentation notes, "By default, DTLS is enabled. We recommend that you use DTLS with AnyConnect."

Scroll to Top