300-815 practice question 3 of 30

After configuring a Cisco CallManager Express with Cisco Unity Express, inbound calls from the PSTN SIP trunk receive a ring tone for 20 seconds and then a busy signal instead of voicemail. Which configuration fixes this problem?

Full set: 221 questions
Answer options
A: Router(config)# voice service voip Router(conf-voi-serv)#allow-connections h323 to h323
B: Router(config)#dial-peer voice 2 voip Router(config-dial-peer)#no vad
C: Router(config)# voice service voip Router(conf-voi-serv)#allow-connections voice-mail mod
D: Router(config)# voice service voip Router(conf-voi-serv)#no supplementary-service sip moved-temporarily Correct answer
Correct Answer:
D. Router(config)# voice service voip Router(conf-voi-serv)#no supplementary-service sip moved-temporarily
Explanation

The described symptom—a 20-second ring followed by a busy signal when calls should go to voicemail—is characteristic of a failed call forward over a SIP trunk. When a call is forwarded (e.g., on no-answer), CME can send a SIP 302 Moved Temporarily message to the provider, redirecting the call. Many service providers do not support this or block it for security reasons, causing the forward to fail. The command no supplementary-service sip moved-temporarily disables this behavior, forcing the CME to handle the call transfer itself (a process known as hair-pinning), which resolves the issue.

Why Incorrect

A. The allow-connections h323 to h323 command is for H.323 calls, but the scenario specifies a PSTN SIP trunk.
B. Disabling Voice Activity Detection (no vad) addresses potential audio quality issues, not call routing or forwarding failures.
C. allow-connections voice-mail mod is not a valid Cisco IOS command. The correct syntax is allow-connections sip to sip.

References

1. Cisco Unified Communications Manager Express System Administrator Guide, "Configuring SIP Trunks" chapter, "Troubleshooting SIP Trunks" section. This section often discusses issues with supplementary services and call transfers.

2. Cisco IOS SIP Configuration Guide, Release 15M&T, "Configuring SIP Supplementary Services" chapter. The guide explains that no supplementary-service sip moved-temporarily disables the 302 response for call forwarding, forcing the gateway to stay in the signaling path.

Scroll to Top