300-815 practice question 5 of 30

The administrator of ABC company is troubleshooting a one-way audio issue for a call that uses H.323 protocol (slow-start mode). The administrator…

Full set: 221 questions

The administrator of ABC company is troubleshooting a one-way audio issue for a call that uses H.323 protocol (slow-start mode). The administrator requests that you provide the IP and port information of the Real- Time Transport Protocol traffic that had the one-way audio call. You gather the H.225 and H.245 messages for one of the one-way audio calls. Where can you find the RTP IP and port information for both sides? (Note: This call flow has not invoked any media resources like MTP or transcoders).

Answer options
A:

A. H.245 Terminal Capability Set

B:

B. H.245 Open Logical Channel

Correct answer
C:

C. H.225 Connect

D:

D. H.245 Open Logical Channel Ack

Correct Answer:
B. B. H.245 Open Logical Channel
Explanation

In an H.323 slow-start call, call signaling (H.225) and media control (H.245) are handled separately. After the initial H.225 signaling sets up the call, a separate H.245 control channel is established. On this channel, endpoints exchange capabilities and then open media streams using the OpenLogicalChannel (OLC) message. The OLC message from an endpoint contains the proposed codec and, critically, the specific IP address and RTP port number on which it wants to receive the media stream. To find the RTP information for both sides, an administrator must inspect the OLC messages sent by each endpoint.

Why Incorrect

A. The H.245 Terminal Capability Set message lists all supported codecs and features but does not specify the IP/port for a specific media stream.
C. In H.323 slow-start, the H.225 Connect message does not contain media channel information; it only indicates that the call is connected.
D. The H.245 Open Logical Channel Ack confirms the channel and contains the acknowledging endpoint's receive IP/port, but the initial request is the OLC.

References

1. ITU-T. (2009). Recommendation H.245: Control protocol for multimedia communication. Section 7.2, "Logical channel signalling procedures," and Table 13, "OpenLogicalChannel message content." This standard defines the OLC message and specifies that it includes the mediaControlChannel which contains the transport address (IP/port).

2. Cisco. (2013). Troubleshooting Cisco IP Telephony and Video (CTCOLLAB) Foundation Learning Guide. Chapter 5, "Troubleshooting Call Setup Issues". This guide details H.323 call flows, explaining that media details in slow-start are exchanged via H.245 OLC/OLC Ack messages.

3. Davidson, J., & Peters, J. (2000). Voice over IP Fundamentals. Cisco Press. Chapter 6, "H.323," section "H.245." This book explains the role of H.245 messages, including OLC, for opening media channels and exchanging RTP port information.

Scroll to Top