301A practice question 16 of 25
An TLM Specialist has an Exchange that must use the LTM device to route traffic to the internet. Which SNAT/NAT configure allows the Exchange server’s traffic access the internet through the LTM device?
Full set: 147 questionsA standard SNAT object on an F5 LTM device allows an administrator to map one or more original source IP addresses to a translation address. By creating a SNAT and specifying the Exchange server's IP address in the "Origin List," the LTM can specifically translate outbound traffic from that server, enabling its access to the internet. This method provides the most granular and direct control for the specified requirement, as it targets only the traffic originating from the designated server(s).
A. NAT: A NAT object in F5 LTM is used for destination address translation (DNAT), typically for inbound traffic, mapping a public IP to a private server IP. It does not handle outbound source address translation.
B. SNAT Pool: A SNAT Pool is a list of translation IP addresses. While it is a component used in a SNAT configuration, it is not the configuration rule itself that enables the traffic routing for a specific server.
D. SNAT Automap: SNAT Automap is a simpler SNAT configuration that uses a self-IP of the LTM as the translation address. It is typically applied to all traffic on a VLAN or through a virtual server, making it less specific than defining a SNAT for a particular server.
1. F5 BIG-IP TMOS: Routing Administration Manual: In the chapter "Network Address Translation and Source Network Address Translation," the section "Configuring a standard SNAT" describes creating a SNAT object. It states, "A standard SNAT is an object that you create to map one or more original IP addresses to a specific translation address that you define." The configuration requires specifying the "Origin List," which contains the source IP addresses to be translated (e.g., the Exchange server). (Refer to the section on "Implementing SNATs").
2. F5 Knowledge Base Article K7820: Overview of SNAT features: This article details different SNAT types. It explains that a "standard SNAT" is defined for a specific list of original IP addresses. This contrasts with SNAT Automap, which applies more broadly. The "SNAT List" in the question refers to this standard SNAT configuration where the origin is a list of one or more specific addresses.
3. F5 Knowledge Base Article K6912: Configuring a SNAT to route traffic through the BIG-IP system: This guide provides a step-by-step procedure for creating a standard SNAT. Step 4 involves specifying the server's IP address in the "Origin List" field, confirming that this configuration is the correct method for enabling outbound access for a specific internal server.
Keep practicing
Take the free 301A practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 301A practice questions
- Question 1An application is expected to maintain more than 100,000 concurrent TCP connections to a …
- Question 2A virtual server is using a TCP profile based on the top-wan-optimized profile for a stre…
- Question 4An LTM Specialist needs to gather website statistics such as latency and throughput on th…
- Question 5An LTM Specialist is configuring a virtual server with an IP address. Which configuration…
- Question 7An TLM Specialist needs to configure a virtual server to terminate SSL connection on the …
- Question 9A LTM device needs to load balance active and passive FTP traffic while using only a sing…
