CLSSGB-001 practice question 30 of 30

Select all the statements that are true after reviewing the Capability Analysis shown here. (Note: There are 4 correct answers).

Full set: 200 questions
Answer options
A: The process is out of Control. Correct answer
B: The process is properly assumed to be a Normal process. Correct answer
C: The Mean of the process moving range is 1.78.
D: This Capability Analysis used subgroups. Correct answer
E: Majority of the dimensional values are outside of the tolerance than within.
Correct Answer:
A. The process is out of Control.; B. The process is properly assumed to be a Normal process.; D. This Capability Analysis used subgroups.
Explanation

The analysis of the provided charts leads to the following conclusions:
1. The process is out of statistical control. The X-bar chart clearly shows multiple data points (subgroup means) falling outside the upper (UCL) and lower (LCL) control limits, which indicates the presence of special cause variation. A stable, in-control process is a prerequisite for a valid capability analysis.
2. The assumption of normality is appropriate. The Normal Probability Plot shows the data points closely following the fitted line, and the Anderson-Darling test yields a P-value of 0.844. Since this P-value is significantly greater than a typical alpha level (e.g., α = 0.05), the null hypothesis that the data follows a normal distribution cannot be rejected.
3. The analysis was performed using subgrouped data. This is evident from the use of an X-bar chart (for subgroup means) and an R chart (for subgroup ranges).

Why Incorrect

C. The Mean of the process moving range is 1.78. This is incorrect. The chart provided is an R chart (Range chart) for subgroups, not a Moving Range chart. The center line on the R chart clearly states that the mean of the subgroup ranges (R-bar) is 2.500.
E. Majority of the dimensional values are outside of the tolerance than within. This is incorrect. The "Overall Capability" section predicts a total of 130,000 Parts Per Million (PPM) outside the specification limits. This translates to 13% of the output, meaning the majority (87%) is predicted to be within tolerance.

References

1. Montgomery, D. C. (2013). Introduction to Statistical Quality Control (7th ed.). John Wiley & Sons.

For Answer A: Chapter 6, Section 6.2, "Control Charts for Variables," explains that points outside the control limits on an X-bar chart are a primary indicator of an out-of-control process (p. 283).

For Answer D: Chapter 6, Section 6.2, details the construction and use of X-bar and R charts specifically for data collected in rational subgroups (p. 279).

For Incorrect Option C: The center line of the R chart is defined as R-bar (R̄), the average of the subgroup ranges (p. 282). A moving range is used for individual observations (I-MR chart), not subgrouped data.

2. Pyzdek, T., & Keller, P. A. (2018). The Six Sigma Handbook (5th ed.). McGraw-Hill Education.

For Answer B: Chapter 16, "Process Capability," discusses the importance of testing for normality before conducting a capability analysis. A high P-value (typically > 0.05) from a normality test like Anderson-Darling supports the normality assumption (Section: "Checking for Normality").

For Incorrect Option E: Chapter 16 also defines Parts Per Million (PPM) as a metric for nonconformance. 130,000 PPM directly translates to a 13% defect rate, which is not a majority.

Scroll to Top