CWDP-305 practice question 3 of 35

What type of protection should be provided to outdoor antenna installations? Response:

Full set: 341 questions

Domain Design Deployment and Validation

Answer options
A: Static electricity
B: Brownouts
C: Lightning surge suppression Correct answer
D: A/C spikes
Correct Answer:
C. Lightning surge suppression
Explanation

Outdoor antenna installations are exposed to atmospheric conditions, making them highly vulnerable to lightning strikes, either direct or nearby. A lightning surge suppressor (or arrestor) is an essential protective device installed in the RF coaxial cable line, typically near the building entrance. Its function is to divert the massive electrical surge from a lightning strike to a low-impedance path to ground. This prevents the high-energy surge from traveling down the cable and destroying the sensitive radio components of the connected access point, bridge, or other network equipment. Proper grounding of the suppressor is critical for its effectiveness.

Why Incorrect

A. Static electricity: While lightning arrestors also dissipate static charge, the primary and most destructive threat they are designed to mitigate is a lightning-induced surge.
B. Brownouts: This is a sustained low-voltage condition from the A/C power grid and is unrelated to protecting an antenna from atmospheric electrical events.
D. A/C spikes: This is a transient over-voltage condition from the A/C power grid; it affects the power supply of equipment, not the passive antenna and its RF cable. ---

References

1. Vendor Documentation: Cisco Systems, "Cisco Aironet 1560 Series Outdoor Access Point Hardware Installation Guide," Chapter: Installing the Access Point, Section: Installing a Lightning Arrestor. The guide states, "If you are installing an access point with external antennas, you must install a lightning arrestor to protect the access point and other networking equipment from power surges caused by lightning."

2. Official Standards: National Fire Protection Association (NFPA), NFPA 70, National Electrical Code (NEC), 2020 Edition. Article 810, "Radio and Television Equipment," Section 810.20, "Antenna Discharge Units — Transmitting and Receiving Stations." This section mandates that each conductor of a lead-in from an outdoor antenna shall be provided with a listed antenna discharge unit (lightning arrestor).

3. Vendor Documentation: Cambium Networks, "PTP 820C Installation Guide," Version 10002, January 2018. Section 2-10, "Lightning Protection," states, "It is recommended to install a lightning protection device on the copper Ethernet cable at the building entry point... The Lightning Protection Unit (LPU) is a high-speed, high-current, solid-state device that provides protection from lightning and other electrical surge events." This illustrates the industry-standard practice for all outdoor radio installations.

Scroll to Top