You are installing an HCP G10 and are now setting the front-end connectivity. The customer has provided you with IP addresses for their network for…

The installation of a Hitachi Content Platform (HCP) G10 appliance involves several configuration steps on each individual node. As part of the overall OS installation procedure, two primary and distinct IP addresses must be set for each node. First, the Baseboard Management Controller (BMC) IP address is configured for out-of-band hardware management and to facilitate the remote installation process. Second, the front-end IP address is configured for the operating system, enabling the node to communicate on the customer's data network and join the HCP cluster. These two actions are fundamental, per-node requirements outlined in the installation process.

B. Set the NTP IP address(es): NTP server configuration is a cluster-wide setting applied through the HCP System Management Console after the nodes are installed and the cluster is formed, not a per-node setting during OS installation.

D. Set the gateway IP address: While the gateway IP address is essential and configured for each node, it is a parameter of the front-end network interface configuration, not a separate, distinct action. The action is "Set the front-end IP address," which includes the IP, subnet mask, and gateway.

1. Hitachi Content Platform (HCP) G Series Hardware Installation and Initial Configuration Guide (MK-92HCP057-11)

Page 3-2, Section: "Configuring the BMC network settings": This section explicitly details the procedure for setting the BMC IP address, subnet mask, and default gateway for each node individually before proceeding with the main software installation. This supports option A.

Page 4-1, Section: "Installing the HCP software": This chapter describes the process of running the installer, which uses a configuration file or prompts to set the node's front-end network parameters. The "HCP G10 and G11 configuration worksheet" referenced on page 2-2 includes mandatory fields for each node's "Front-end IP address," confirming this is a required per-node action. This supports option C. The same worksheet shows the "Front-end default gateway" as a sub-component of the front-end network configuration, supporting the reasoning for why D is incorrect as a distinct action.

The guide's table of contents and overall structure treat NTP configuration as a post-installation task, managed at the system level, which supports why B is incorrect.