300-425 practice question 7 of 25

An engineer is implementing a wireless design for a service provider. The design includes a Catalyst 9800, a stack of two Catalyst 9300X- 48HX…

Full set: 286 questions

Domain Wired and Wireless Infrastructure

An engineer is implementing a wireless design for a service provider. The design includes a Catalyst 9800, a stack of two Catalyst 9300X- 48HX switches, and 9166 APs. Each AP must be named using the Floor-439412509-01X sting where X is the area number. The engineer wants to connect the APs to the switch stack using POE. How many APs must the engineer connect to the stack so the APs run using full functionalities?
Answer options
A: all ports on switch 2 of the stack
B: all ports on switch 1 of the stack
C: all ports of the switches Correct answer
D: half ports per switch
Correct Answer:
C. all ports of the switches
Explanation

The Cisco Catalyst 9166 Access Point requires 802.3bt (UPoE) power to operate with full functionality. Its maximum power consumption is 30.96W. The Cisco Catalyst 9300X-48HX switch is a high-power model that provides 90W Cisco UPOE+ (which satisfies the 802.3bt requirement) on all 48 of its ports. A stack of two C9300X-48HX switches has a total of 96 ports. With adequate power supplies (e.g., dual 1900W AC PSUs), the stack's total PoE budget (3600W) is more than sufficient to power all 96 APs simultaneously (96 APs 30.96W/AP ≈ 2973W). Therefore, all ports on both switches in the stack can be used to connect and power the APs for full functionality.

Why Incorrect

A. all ports on switch 2 of the stack: This is incorrect because it arbitrarily limits the connection to only one switch in the stack, while both switches are capable of powering the APs.
B. all ports on switch 1 of the stack: This is incorrect for the same reason as option A; it unnecessarily restricts the design to a single switch when the entire stack is available.
D. half ports per switch: This is incorrect as it represents an arbitrary and unnecessary limitation. The switch hardware and PoE budget support using all available ports.

References

1. Cisco Catalyst 9166 Series Access Points Data Sheet: In Table 10

"Power consumption

" the document specifies that "Full functionality" requires 802.3bt (UPoE) power

with a maximum power draw of 30.96W. It explicitly states that 802.3at (PoE+) results in "Reduced functionality."

Source: Cisco.com

"Cisco Catalyst 9166 Series Access Points Data Sheet"

Document ID: 18442983335710153

Published: 20-Mar-2024.

2. Cisco Catalyst 9300 Series Switches Data Sheet: In Table 2

"Cisco Catalyst 9300 Series models

" the C9300X-48HX model is listed as having "48 ports 90W Cisco UPOE+." This confirms every port can supply the required power.

Source: Cisco.com

"Cisco Catalyst 9300 Series Switches Data Sheet"

Document ID: 18442983335709985

Updated: 15-May-2024.

3. Cisco Catalyst 9300 Series Switches Data Sheet: In Table 6

"PoE power

" it is shown that a C9300X switch with a 1900WAC power supply (C9K-PWR-1900WAC-R) has a total available PoE budget of 1800W. With two such switches in a power stack

the total budget is 3600W.

Source: Cisco.com

"Cisco Catalyst 9300 Series Switches Data Sheet"

Document ID: 18442983335709985

Updated: 15-May-2024.

Scroll to Top