300-425 practice question 4 of 25
An engineer must deploy a wireless network in an open-plan environment that has three SSIDs using the 5 GHz band set to 40 MHz. Co-channel interference must be reduced. Which two actions must be taken? (Choose two.)
Full set: 286 questionsDomain Site Survey
To reduce co-channel interference (CCI) in a high-density or open-plan environment, the primary strategies are to increase the number of available channels and decrease the RF cell size. Decreasing channel bonding from 40 MHz to 20 MHz effectively doubles the number of non-overlapping channels available in the 5 GHz band. This allows for a more efficient channel reuse plan, significantly reducing the probability that adjacent access points (APs) will operate on the same channel. Reducing the transmit power of the APs shrinks their individual RF coverage cells. In an open-plan environment where signals propagate far, smaller cells prevent APs on the same channel from hearing each other, which is the definition of co-channel interference.
A. Increase the number of SSIDs. This increases management frame overhead (beacons, probe responses), which consumes airtime but does not directly address or mitigate co-channel interference.
B. Increase channel bonding in the 2.4 GHz band to 40 MHz. This action is irrelevant as the problem is in the 5 GHz band. Furthermore, using 40 MHz channels in the 2.4 GHz band is highly discouraged as it drastically increases CCI in that band.
C. Disable band steering. Band steering is a client-side mechanism to encourage dual-band clients to use the 5 GHz network. Disabling it has no effect on inter-AP co-channel interference.
1. Cisco Enterprise Mobility 8.5 Design Guide.
Reference for option D: In Chapter: "High Density Wi-Fi Design
" Section: "Channel Width
" it states
"For high-density deployments
it is highly recommended to use 20-MHz channels. Using 20-MHz channels maximizes the number of available channels to the system." This directly supports using narrower channels to mitigate CCI.
Reference for option E: In Chapter: "High Density Wi-Fi Design
" Section: "Cell Size
" it explains
"The goal is to reduce the cell size to avoid co-channel interference... The most direct way to control the cell size is by tuning the transmit power of the APs."
2. Radio Resource Management under Unified Wireless Networks White Paper.
Reference for option E: The section "Transmit Power Control (TPC) Algorithm" states
"The goal of the TPC is to achieve the best possible coverage while reducing co-channel interference." It achieves this by adjusting AP power levels downward to shrink cell sizes where appropriate.
Reference for option D: The section "Dynamic Channel Assignment (DCA) Algorithm" describes how the system assigns channels to minimize interference. The effectiveness of DCA is greatly enhanced when more channels are available
which is achieved by using 20 MHz channel widths instead of 40 MHz or 80 MHz.
Keep practicing
Take the free 300-425 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 300-425 practice questions
- Question 2A wireless consultant reviewing the installation of an old wireless network. The existing…
- Question 3A company is in the process of relocating to a new force space and ends out that the Inte…
- Question 5A hospital wireless environment was designed with these characteristics: • RF coverage • …
- Question 6A customer has this wireless design: • two Cisco Catalyst 9800 Series wireless controller…
- Question 7An engineer is implementing a wireless design for a service provider. The design includes…
- Question 8Which authentication method is most scalable for enterprise WLAN deployments?
