CTS practice question 11 of 35
[Developing AV Solutions]Assuming that the screen and projector are both Ethernet controllable devices, where does the control system for the AV…
Full set: 254 questions[Developing AV Solutions]
Assuming that the screen and projector are both Ethernet controllable devices, where does the control system for the AV solution need to exist?
The defining characteristic of Ethernet-controllable devices is that they communicate over an IP network. For a control system (e.g., a control processor) to send commands and receive feedback from these devices, it must also be connected to the same logical network. The physical location of the control processor—whether in a rack, a projection room, or elsewhere—is secondary. The essential requirement is the network connection that provides the pathway for communication between the controller and the controlled devices.
B. The control system can be in a rear projection room, but this is not a requirement; the network connection is the actual requirement.
C. A dedicated rack is a common and best-practice location, but the system would still be non-functional without being connected to the network.
D. This is incorrect for two reasons: the devices are specified as Ethernet (IP) controllable, not serial, and the physical location is not the defining factor.
1. CTS Certified Technology Specialist Exam Guide, Third Edition, AVIXA, 2020, Chapter 8: Control Systems, pp. 308-310. Explains various control signal types, including IP-based control over a network.
2. Grimes, B., Networked AV Systems, AVIXA, 2014, Chapter 2: Networking Fundamentals, pp. 25-27. Discusses how devices communicate on a network using IP addresses, which is the foundation of IP control.
3. Crestron Electronics, Inc. "4-Series Control Systems Product Manual." Official vendor documentation for modern control processors specifies Ethernet connectivity as the primary interface for programming and controlling IP-enabled third-party devices.
Keep practicing
Take the free CTS practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other CTS practice questions
- Question 1[Developing AV Solutions]Which method of control is supported by HDBaseT?
- Question 2[Conducting a Needs Assessment] During a site survey, a client states that there will be …
- Question 3[Developing AV Solutions] According to AVIXA Standards, what is the MINIMUM load rating f…
- Question 4[Developing AV Solutions] What key specification of an owner furnished credenza will a te…
- Question 7[Developing AV Solutions] In an audiovisual system where a touch panel is to be connected…
- Question 8[Developing AV Solutions]After there is an approved labor change to a project, what shoul…
