CWNA-109 practice question 17 of 25

ABC Company is planning to install a new 802.11ac WLAN, but wants to upgrade its wired infrastructure first to provide the best user experience…

Full set: 122 questions
ABC Company is planning to install a new 802.11ac WLAN, but wants to upgrade its wired infrastructure first to provide the best user experience possible. ABC Company has hired you to perform the RF site survey. During the interview with the network manager, you are told that the new Ethernet edge switches will support VoIP phones and 802.11 access points, both using 802.3 PoE. After hearing this information, what immediate concerns do you note?
Answer options
A: The power budget in the edge switches must be carefully planned and monitored based on the number of supported PoE devices. Correct answer
B: The edge Ethernet switches should support Ether-channel to get the best results out of the network.
C: VoIP phones and 802.11 access points should not be powered by the same edge switch due to distortion.
D: If the switches are in optimal locations for VoIP phones, they are likely to be suboptimal locations for 802.11 APs
Correct Answer:
A. The power budget in the edge switches must be carefully planned and monitored based on the number of supported PoE devices.
Explanation

The most immediate and critical concern is the total power budget of the Power over Ethernet (PoE) switches. Each switch has a maximum power output capacity. Both 802.11ac access points (especially Wave 2 models) and VoIP phones are Powered Devices (PDs) that draw power from the switch. 802.11ac APs can be particularly power-hungry, often requiring 802.3at (PoE+) which delivers up to 25.5W. The cumulative power requirement of all connected APs and phones must be calculated and compared against the switch's total power budget. Exceeding this budget will result in some devices not receiving power, leading to a failed deployment.

Why Incorrect

B. EtherChannel addresses uplink bandwidth aggregation, which is a valid design consideration for high-throughput 802.11ac networks, but it is secondary to the fundamental requirement of providing adequate power for the devices to function.
C. This statement is technically false. PoE delivers standardized DC power and does not cause "distortion" or interference between different types of devices connected to the same switch.
D. This confuses the location of the infrastructure (switches in a wiring closet) with the end devices. APs and phones are placed in their optimal locations and connected via structured cabling; the switch's location does not constrain their placement.

References

1. Coleman, D. D., & Westcott, D. A. (2021). CWNA Certified Wireless Network Administrator Study Guide: Exam CWNA-109 (5th ed.). Wiley.

Page 558, Chapter 14, "Power over Ethernet (PoE)": The text explains, "A PoE switch has a total power budget, which is the total amount of power that the switch can provide to all the powered devices that are connected to it... It is important to make sure that the total power budget of the switch is not exceeded." This directly supports the need for careful power budget planning.

2. IEEE Std 802.3-2018, IEEE Standard for Ethernet.

Section 2, Clause 33, "Data Terminal Equipment (DTE) Power via Media Dependent Interface (MDI)": This clause defines the specifications for 802.3at (PoE+), which allows a Powered Device (PD) to receive up to 25.5 W. This confirms that high-power devices like 802.11ac APs have specific power requirements that must be factored into the total budget.

3. Cisco. (2023). Cisco Catalyst 9200 Series Switches Data Sheet.

"Power Supply and PoE Power Capacity" Table: Vendor documentation like this explicitly lists the "Total PoE Power" for each switch model (e.g., 370W, 740W). This highlights that the power budget is a finite, model-specific hardware limitation that must be a primary consideration during network design and procurement.

Scroll to Top