CWNA-109 practice question 25 of 25

What statement about 802.3, Clause 33 Power over Ethernet is true?

Full set: 122 questions
Answer options
A: When using CAT5 cabling, you increase the maximum draw available to the PD over that available with CAT6.
B: Only endpoint PSEs are supported.
C: Only midspan PSEs are supported.
D: The lowest voltage drop is achieved when using CAT6 cable instead of Cat5 or CAT5e. Correct answer
Correct Answer:
D. The lowest voltage drop is achieved when using CAT6 cable instead of Cat5 or CAT5e.
Explanation

The IEEE 802.3 standard, Clause 33 (also known as 802.3af PoE), relies on the DC resistance of the Ethernet cable for power delivery. Category 6 (CAT6) cabling is specified with thicker copper conductors (typically 23 AWG) compared to Category 5 (CAT5) or Category 5e (CAT5e) cabling (typically 24 AWG). A thicker conductor has lower DC resistance. According to Ohm's Law (V=IR), a lower resistance (R) over the length of the cable results in a smaller voltage drop (V) for the same amount of current (I) being delivered to the Powered Device (PD). This improves power delivery efficiency.

Why Incorrect

A. CAT6 cabling has lower resistance than CAT5, which reduces power loss and improves power availability to the PD, not decreases it.
B. The 802.3 Clause 33 standard explicitly defines and supports both endpoint and midspan Power Sourcing Equipment (PSE) types.
C. The 802.3 Clause 33 standard explicitly defines and supports both endpoint and midspan Power Sourcing Equipment (PSE) types.

References

1. CWNP, LLC. (2023). CWNA Certified Wireless Network Administrator Official Study Guide (6th ed., CWNA-109). Chapter 10, "Power over Ethernet (PoE)," section on "Cabling," which states: "Higher-quality cabling, such as CAT6A, has lower DC resistance because the copper wires are thicker (23 AWG vs. 24 AWG in CAT5e). Lower DC resistance means less power is dissipated as heat in the cable and more power is delivered to the PD."

2. IEEE Std 802.3-2018. IEEE Standard for Ethernet. Section 2, Clause 33.

Clause 33.2.2, "PSE PI": Defines both Endpoint PSE and Midspan PSE, invalidating options B and C.

Clause 33.1.4, "Link section": Specifies the maximum channel DC loop resistance (25 Ω for 2-pair power delivery). The ability to meet this requirement is directly related to the cable's conductor gauge and quality, where CAT6 generally outperforms CAT5/5e.

3. Kurose, J. F., & Ross, K. W. (2021). Computer Networking: A Top-Down Approach (8th ed.). Pearson. Chapter 5, "The Link Layer: Links, Access Networks, and LANs," discusses the physical properties of twisted-pair cabling, noting that lower gauge numbers (like 23 AWG in CAT6) correspond to thicker wires and lower electrical resistance, which is critical for applications like PoE.

Scroll to Top