300-110 practice question 6 of 10

A community bank has three campus locations and one HQ with the data center. Each campus has four Cisco Catalyst 9120 APs. Poor WAN uplinks cause…

Full set: 94 questions
A community bank has three campus locations and one HQ with the data center. Each campus has four Cisco Catalyst 9120 APs. Poor WAN uplinks cause impacted connectivity back to HQ, and each campus is planned to have its own EWC controller based on C9120 AP to keep traffic local. Guest WLAN will be routed locally. Employee WLAN must be authenticated 802.1x PEAP via HQ ISE but can pass traffic locally once authenticated. HQ WLC will be the primary backup WLC for each WLC. Which design approach should the consulting engineer take?
Answer options
A: One C9120 AP in each campus must be converted to EWC mode, and the preferred controller is set to that AP with HQ WLC set as N+1 backup. The campus guest WLAN will use local web auth on guest VLAN, and employee WLAN will need the HQ AAA server to be added to EWC. Correct answer
B: Two C9120 campus APs must be converted to EWC mode, one for the active controller and the other for standby set as N+1 backup. The campus guest WLAN will use local web auth on guest VLAN, and employee WLAN will need the HQ AAA server added to EWC.
C: Two C9120 campus APs must be converted to EWC mode, one for the active controller and the other for standby with HQ WLC as N+1 backup. The campus guest WLAN will use the guest anchor to HQ WLC for guest VLAN access, and employee WLAN will need the HQ AAA server added to EWC.
D: One C9120 campus AP must be converted to EWC mode, and the preferred controller is set to that AP with HQ WLC paired as mobility peer and configured as N+1 backup. The campus guest WLAN will use local web auth on guest VLAN. The campus employee WLAN will need the guest anchor back to the HQ employee WLAN.
Correct Answer:
A. One C9120 AP in each campus must be converted to EWC mode, and the preferred controller is set to that AP with HQ WLC set as N+1 backup. The campus guest WLAN will use local web auth on guest VLAN, and employee WLAN will need the HQ AAA server to be added to EWC.
Explanation

Each campus needs local wireless control and local forwarding because WAN connectivity to HQ is poor. A Catalyst 9120 AP can run Embedded Wireless Controller mode, so one AP per campus should be converted to EWC and made the preferred controller for that campus AP group. The HQ WLC can be configured as the N+1 backup controller if the local EWC is unavailable. The guest WLAN requirement says guest traffic must be routed locally, so local web authentication on the local guest VLAN is appropriate; anchoring guest traffic to HQ would violate the design goal. Employee WLAN users can authenticate against HQ ISE via PEAP/802.1X by adding the HQ AAA server to each campus EWC, while data remains locally switched after authentication.

Why Incorrect

B. It omits the required HQ WLC backup and incorrectly uses a second local EWC as the stated N+1 design.
C. It anchors guest traffic to HQ, contradicting the requirement that guest WLAN traffic be routed locally.
D. It incorrectly anchors the employee WLAN to HQ and adds unnecessary mobility peering for the stated local-switching requirement.

References

- Cisco, Embedded Wireless Controller on Catalyst Access Points Configuration Guide, section “Embedded Wireless Controller on Catalyst Access Points”; describes C9120 EWC deployment.

- Cisco, Embedded Wireless Controller on Catalyst Access Points Configuration Guide, section “Configuring the Preferred Controller”; covers assigning APs to a preferred controller.

- Cisco, Cisco Catalyst 9800 Series Wireless Controller Software Configuration Guide, section “N+1 High Availability”; describes primary/backup controller behavior.

- Cisco, Embedded Wireless Controller Configuration Guide, sections “Configuring AAA Servers” and “Configuring Local Web Authentication”; covers RADIUS/ISE and local guest authentication.

Scroll to Top