300-110 practice question 3 of 10

An engineer is estimating the loss between two floors of an office building. Using Ekahau, they have measured -45 dBm at the ground level of the floor with the access point and -50 dBm at the ceiling level of the floor below it. Which value is the loss of the floor?

Full set: 94 questions
Answer options
A: -95 dB
B: -5 dB
C: 5 dB Correct answer
D: 95 dB
Correct Answer:
C. 5 dB
Explanation

In RF engineering, attenuation or signal loss is calculated as the difference in signal strength before and after passing through an obstacle. The signal strength measured at the ground level (before passing through the floor) is -45 dBm. The signal strength measured at the ceiling of the floor below (after passing through the floor) is -50 dBm. The absolute difference between these two measurements is 5 dB (-45 dBm minus -50 dBm). Because the question specifically asks for the "loss," it is expressed as a positive decibel (dB) value representing the amount of signal attenuation caused by the floor's physical material.

Why Incorrect

A. -95 dB: This is the incorrect sum of the two negative dBm values, which does not represent attenuation or signal loss.
B. -5 dB: Loss is inherently a measure of reduction, so stating a "loss of -5 dB" implies a signal gain, which is mathematically and physically incorrect here.
D. 95 dB: This is the incorrect sum of the absolute values of the measurements, rather than the difference between them.

References

1. Cisco Enterprise Wireless Design Guide, Section: "WLAN RF Design Considerations" (RF Math and Attenuation).

2. IEEE 802.11 Wireless LANs, "RF Engineering Principles," Section on Signal Attenuation and Decibel Math.

Scroll to Top