CWDP-305 practice question 28 of 35

What limitation exists when WMM is not enabled on an 802.11n WLAN?

Full set: 341 questions

Domain WLAN Design Troubleshooting

Answer options
A: 802.11 QoS will not be available Correct answer
B: The maximum channel-width will be 20MHz
C: EDCA values will change
D: Only two ACs will be available
Correct Answer:
A. 802.11 QoS will not be available
Explanation

The IEEE 802.11n standard mandates that a station must implement and use Quality of Service (QoS) capabilities to operate in High Throughput (HT) mode. Wi-Fi Multimedia (WMM) is the Wi-Fi Alliance certification that provides these QoS features based on the IEEE 802.11e standard. If WMM is disabled on a wireless LAN, the required QoS mechanisms are not available. As a result, 802.11n devices cannot use HT data rates (MCS rates) and are forced to communicate using legacy 802.11a/g data rates (up to 54 Mbps). This lack of QoS is the fundamental limitation preventing access to all 802.11n enhancements.

Why Incorrect

B. The maximum channel-width will be 20MHz: This is a consequence, not the primary limitation. The use of 40 MHz channels is an HT feature, which is disabled because the foundational QoS requirement is not met.
C. EDCA values will change: This is incorrect. If WMM is not enabled, the Enhanced Distributed Channel Access (EDCA) mechanism is not used at all. The network reverts to the legacy Distributed Coordination Function (DCF).
D. Only two ACs will be available: This is incorrect. WMM/EDCA utilizes four Access Categories (ACs). When WMM is disabled, no ACs are available because the system does not use the EDCA mechanism. ---

References

1. IEEE Std 802.11™-2020 (Revision of IEEE Std 802.11-2016). IEEE Standard for Information Technology—Telecommunications and Information Exchange between Systems Local and Metropolitan Area Networks—Specific Requirements - Part 11: Wireless LAN Medium Access Control (MAC) and Physical Layer (PHY) Specifications.

Section 27.1, "HT overview," Page 2893: "An HT STA shall implement the QoS facility." This clause establishes that QoS is a mandatory component for any station to be considered a High Throughput (HT) station.

2. Coleman, D. D., & Westcott, D. A. (2021). CWAP Certified Wireless Analysis Professional Official Study Guide (CWAP-404), 4th Edition. Wiley.

Chapter 8, "MAC Layer," Page 238: "The 802.11n amendment and all subsequent amendments require that QoS be enabled to use the high throughput (HT), very high throughput (VHT), and high efficiency (HE) PHYs. If WMM is disabled on an access point, 802.11n/ac/ax clients can connect only by using the 802.11a/g legacy rates (OFDM)." This directly links the disabling of WMM to the inability to use HT PHYs.

Scroll to Top