CWDP-305 practice question 27 of 35
What might limit the ability to locate 802.11 clients using a WLAN infrastructure without an 802.11 tag?(Choose all that apply.)
Full set: 341 questionsDomain WLAN Design Troubleshooting
The ability of a WLAN infrastructure to locate an 802.11 client device (without a dedicated tag) is fundamentally dependent on receiving radio frequency (RF) signals transmitted by that client. Location engines typically use metrics such as Received Signal Strength Indication (RSSI) from multiple Access Points (APs) to calculate the client's position via trilateration. If the client device is powered off (C) or its 802.11 radio is disabled (B), it cannot transmit any frames (e.g., probe requests, data frames). Without these transmissions, the WLAN infrastructure has no signal to detect or measure, rendering location tracking impossible.
A. Lack of 802.11k support: 802.11k provides radio resource management information to clients for better roaming decisions; its absence does not prevent a client's standard transmissions from being used for location tracking.
D. RF channel selection: While operating on a specific channel might limit which APs can hear the client at any given moment, it does not prevent location tracking, as APs can perform off-channel scanning.
1. CWNP, LLC., CWDP-304 Certified Wireless Design Professional Official Study Guide, (2021). Chapter 11, "WLAN Architecture," discusses value-added services like location tracking. The underlying principle described is that location engines rely on data collected by APs from client transmissions. A non-transmitting client provides no data. Specifically, the text explains that RSSI-based location requires the APs to hear the client's frames.
2. Cisco, Cisco DNA Spaces Configuration Guide, (2023). In the "Location Hierarchy and Setup" section, the documentation explains that the system computes a client's location based on RSSI measurements received by the APs. This process inherently requires the client's radio to be active and transmitting. A device that is off or has its radio disabled is not detectable by the APs and therefore cannot be located.
3. Liu, J., et al. (2020). "A Survey on Wi-Fi-Based Indoor Positioning Techniques." IET Communications, 14(9), pp. 1372-1383. Section 2, "Fundamentals of Wi-Fi Positioning," establishes that all Wi-Fi positioning methods, including fingerprinting and trilateration, require the measurement of signal parameters (like RSSI) from the target device. The paper states, "The basic idea of RSSI-based localisation is to measure the signal strength from the target device to several APs with known locations." This confirms that a signal from the target is a prerequisite. (DOI: https://doi.org/10.1049/iet-com.2019.0510)
Keep practicing
Take the free CWDP-305 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other CWDP-305 practice questions
- Question 1Using a SCA means that all APs will be using the same channel in a given layer. How is th…
- Question 2What two 802.11 amendments deal with regulatory and transmission requirements? Response:
- Question 3What type of protection should be provided to outdoor antenna installations? Response:
- Question 4What service must be implemented on your customer's network to authenticate users against…
- Question 5Why does a frame transmitted at 1 Mbps have a greater usable range than the same frame tr…
- Question 6Prior to meeting with the customer for the first time, you should do which of the followi…
