CWDP-305 practice question 12 of 35
When deploying long-distance 802.11 bridge links (10 miles / 16 km), what parameter may be critical for improving data flow by reducing retries caused by the long distances?
Full set: 341 questionsDomain Design Deployment and Validation
In long-distance 802.11 links, the propagation delay—the time it takes for a radio signal to travel from the transmitter to the receiver—becomes a significant factor. A standard 802.11 device expects an acknowledgement (ACK) frame within a specific, short timeout period. For a 16 km link, the round-trip time for the signal can easily exceed this default timeout. This causes the sending station to incorrectly assume the original frame was lost and initiate a retransmission. By increasing the acknowledgement timeout threshold, the radio is configured to wait longer for the ACK, accommodating the propagation delay and preventing unnecessary retries, thus improving data flow.
A. The sequence control field value: This field is used by the MAC layer to reorder frames and detect duplicates; it has no role in managing the timing of frame acknowledgements.
C. The minimum transmit data rate value: While a lower data rate can improve link stability by increasing the link budget, it does not address the fundamental timing issue of ACK frames not returning before the timeout expires due to distance.
D. The CTS-to-self threshold: This is a protection mechanism used to mitigate the hidden node problem, typically in a point-to-multipoint environment. It is not relevant to solving propagation delay issues in a point-to-point link. ---
1. Official Vendor Documentation:
Cisco, Cisco Aironet 1550 Series Outdoor Access Point Configuration Guide, Chapter: Configuring the Radio Interface. In the section "Configuring the Radio Data Rate," the distance command is detailed. The guide states, "Use the distance command in interface configuration mode to tune the 802.11... radio for optimal performance on long-distance point-to-point links. This command adjusts the ACK and CTS timeout values." This directly confirms that adjusting timeout values is the correct procedure for long-distance links.
2. University Courseware:
Stallings, W. (Courseware based on his publications), Data and Computer Communications, 10th ed., Pearson. Chapter 17, "Wireless LANs," discusses the IEEE 802.11 MAC logic. The timing diagrams for CSMA/CA show that if an ACK is not received within a timeout period (derived from SIFS, DIFS, and Slot Time), a retransmission occurs. For long distances, the propagation delay must be factored into this timeout calculation, which standard settings do not account for. (Relevant concepts in Section 17.2, IEEE 802.11 MAC).
3. Peer-Reviewed Academic Publication:
Santi, P. (2012). Mobility Models for Next Generation Wireless Networks. John Wiley & Sons. In Chapter 2, "The IEEE 802.11 Standard," Section 2.2.2 discusses the DCF timing. It explains that the ACKTimeout interval is critical. The text implies that for non-standard deployments, such as long-distance links, this parameter must be adjusted to account for increased propagation delay to avoid spurious retransmissions. (DOI: https://doi.org/10.1002/9781118344781)
Keep practicing
Take the free CWDP-305 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other CWDP-305 practice questions
- Question 1Using a SCA means that all APs will be using the same channel in a given layer. How is th…
- Question 2What two 802.11 amendments deal with regulatory and transmission requirements? Response:
- Question 3What type of protection should be provided to outdoor antenna installations? Response:
- Question 4What service must be implemented on your customer's network to authenticate users against…
- Question 5Why does a frame transmitted at 1 Mbps have a greater usable range than the same frame tr…
- Question 6Prior to meeting with the customer for the first time, you should do which of the followi…
