CWDP-305 practice question 13 of 35
During a post-validation assessment, you have configured a client for 802.1X/EAP but it is not passing authentication. Which areas should you check in the WLAN configuration? Response:
Full set: 341 questionsDomain WLAN Design Troubleshooting
The most fundamental requirement for 802.1X/EAP authentication is successful communication between the authenticator (the AP or WLAN controller) and the authentication server (RADIUS). If the RADIUS server is offline, unreachable due to a firewall, or if the authenticator is configured with an incorrect IP address or UDP port for the server, the authentication requests from the client cannot be processed. Verifying the RADIUS server's status and the corresponding configuration on the WLAN controller/APs is a primary and essential step in troubleshooting EAP authentication failures within the WLAN infrastructure.
B. The RADIUS shared secret is a pre-shared key configured on the authenticator (AP/controller) and the authentication server to secure communication between them, not on the supplicant (client).
C. The authenticator's primary role is to act as a pass-through for EAP messages between the supplicant and the authentication server. EAP type negotiation and support is mainly a concern for those two endpoints.
D. A client's certificate is a component of the supplicant's configuration. While an invalid certificate will cause authentication to fail, it is not an issue within the WLAN infrastructure's configuration. ---
1. Cisco Systems, Inc., "Troubleshoot Identity-Based Networking Services," Cisco IOS XE Gibraltar 16.11.x (Catalyst 9300 Switches) - Security Configuration Guide. In the "Troubleshooting 802.1X" section, the first steps include verifying connectivity to the RADIUS server using ping and checking the RADIUS server configuration status with show radius server-group all. This confirms that checking server status and configuration on the authenticator is a primary step.
2. Aruba Networks (a Hewlett Packard Enterprise company), "Troubleshooting 802.1X," ArubaOS 8.6.0.0 User Guide. In the section "Initial Checks," the guide states, "Verify that the controller has IP connectivity to the RADIUS server... Use the ping command in enable mode to test connectivity." This directly supports verifying server reachability as a key troubleshooting area.
3. University of Cambridge, University Information Services, "RADIUS server debugging," Network Authentication Service documentation. The guide lists primary debugging steps for RADIUS failures, including: "Check that the RADIUS server is running," "Check that the NAS [Network Access Server/Authenticator] can reach the RADIUS server," and "Check that the shared secret is correct." These steps align directly with the checks described in option A.
Keep practicing
Take the free CWDP-305 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other CWDP-305 practice questions
- Question 1Using a SCA means that all APs will be using the same channel in a given layer. How is th…
- Question 2What two 802.11 amendments deal with regulatory and transmission requirements? Response:
- Question 3What type of protection should be provided to outdoor antenna installations? Response:
- Question 4What service must be implemented on your customer's network to authenticate users against…
- Question 5Why does a frame transmitted at 1 Mbps have a greater usable range than the same frame tr…
- Question 6Prior to meeting with the customer for the first time, you should do which of the followi…
