CWDP-305 practice question 33 of 35
You told your customer that multipath fading may be mitigated simply by moving one or both of the receivers antennas a small amount, usually by one to four wavelengths away from its original position. Your customer is prepared to make the change, but does not know the wavelength for 802.11ac. What is the approximate wavelength of an 802.11ac radio wave?
Full set: 341 questionsDomain WLAN Design Troubleshooting
The wavelength (λ) of a radio wave is calculated using the formula λ = c/f, where 'c' is the speed of light (approximately 3 x 10⁸ m/s) and 'f' is the frequency. The 802.11ac standard operates exclusively in the 5 GHz frequency band (5 x 10⁹ Hz). Performing the calculation: λ = (3 x 10⁸ m/s) / (5 x 10⁹ Hz) = 0.06 meters, which is 6 cm. The value of 5.5 cm (2.16 inches) corresponds to a frequency of approximately 5.45 GHz, which falls within the U-NII bands utilized by 802.11ac. Therefore, it is the correct approximate wavelength.
B. A 12 cm wavelength corresponds to the 2.4 GHz frequency band (e.g., 802.11b/g/n), not the 5 GHz band required for 802.11ac.
C. A 15.24 cm wavelength corresponds to a frequency of approximately 1.97 GHz, which is not a standard Wi-Fi frequency.
D. A 45 cm wavelength corresponds to a frequency of approximately 667 MHz, which is used for UHF television broadcasting, not Wi-Fi.
1. IEEE Std 802.11ac™-2013, "Part 11: Wireless LAN Medium Access Control (MAC) and Physical Layer (PHY) Specifications—Amendment 4: Enhancements for Very High Throughput for Operation in Bands below 6 GHz." Section 22.1, "Scope," page 271, states that the amendment specifies operation in frequency bands between 5.150 GHz and 5.850 GHz. This confirms the 5 GHz operational frequency for 802.11ac.
2. Pozar, D. M. (2011). Microwave Engineering (4th ed.). Wiley. Chapter 1, Section 1.2, "Frequency and Wavelength," page 3, provides the fundamental formula relating wavelength, frequency, and the speed of light: λ = c/f. This is a standard textbook used in university electrical engineering curricula.
3. Cisco Systems, Inc. (2017). "802.11ac: The Fifth Generation of Wi-Fi Technical White Paper." Page 4, "802.11ac at a Glance," explicitly states, "The 802.11ac standard is a 5-GHz-only standard." This official vendor document confirms the frequency band used in the wavelength calculation.
Keep practicing
Take the free CWDP-305 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other CWDP-305 practice questions
- Question 1Using a SCA means that all APs will be using the same channel in a given layer. How is th…
- Question 2What two 802.11 amendments deal with regulatory and transmission requirements? Response:
- Question 3What type of protection should be provided to outdoor antenna installations? Response:
- Question 4What service must be implemented on your customer's network to authenticate users against…
- Question 5Why does a frame transmitted at 1 Mbps have a greater usable range than the same frame tr…
- Question 6Prior to meeting with the customer for the first time, you should do which of the followi…
