HQT-4420 practice question 8 of 10
When do you need to check the BIOS configuration on an HCP G10 node?
Full set: 35 questionsWhen an entire HCP G10 node is replaced, the new hardware is introduced with a default or unknown BIOS configuration. It is a mandatory step to enter the BIOS setup on the replacement node to configure specific settings. These settings, including boot mode (UEFI), virtualization technology (VT-d), and power management, must align with the operational requirements of the Hitachi Content Platform cluster. This ensures the new node can boot correctly, be recognized by the system, and function consistently with the other nodes in the cluster. Failure to perform this check and configuration will prevent the node from being successfully integrated.
B. HCP software upgrades are managed at the application and operating system level and do not require modifications to the underlying hardware BIOS settings.
C. Replacing a component like an HBA does not necessitate changes to the main system BIOS; any required configuration is typically within the HBA's own firmware/option ROM.
D. Replacing a failed hard disk drive is a routine storage-level operation, typically hot-swappable, and is managed by the RAID controller without any need for BIOS intervention.
1. Hitachi Vantara Documentation, "Replacing an HCP G10 or G11 Node," Publication Number RG-91HCP023-12, Page 11. The section titled "Configuring the BIOS on the replacement node" explicitly states: "Before you can add the replacement node to the HCP system, you need to configure the BIOS on that node." It then provides a detailed procedure for verifying and setting the required BIOS parameters.
2. Hitachi Vantara Documentation, "HCP G10 and G11 Hardware Installation and Service Guide," Publication Number HS-91HCP022-12, Chapter 5: Servicing HCP Nodes. This guide details the hardware replacement procedures. The procedure for replacing a full node includes the step to configure the BIOS, while the procedures for replacing individual components like HDDs or HBAs do not list this as a required step.
Keep practicing
Take the free HQT-4420 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other HQT-4420 practice questions
- Question 1How is the software update package uploaded to an HCP S10?
- Question 2You are installing an HCP G10 with attached storage. A VSP G1000 is used to provision the…
- Question 3What does the HCP Data Protection Level setting identify?
- Question 4Which statement regarding the Data At Rest Encryption feature (DARE) is correct?
- Question 5You are installing an HCP G10 and are now setting the front-end connectivity. The custome…
- Question 6How should the RAID group(s) and logical volume(s) be configured on an HCP G10 node with …
