JN0-637 practice question 9 of 25
You have deployed automated threat mitigation using Security Director with Policy Enforcer, Juniper ATP Cloud, SRX Series devices, Forescout, and third-party switches. In this scenario, which device is responsible for communicating directly to the third-party switches when infected hosts need to be blocked?
Full set: 115 questionsIn a Juniper Connected Security architecture that includes third-party switches, Policy Enforcer acts as the central orchestration point. When Juniper ATP Cloud identifies an infected host, it notifies Policy Enforcer. Policy Enforcer then communicates this threat information to the integrated Network Access Control (NAC) solution, which in this scenario is Forescout. Forescout, leveraging its multi-vendor capabilities, is the component that communicates directly with the third-party switch to apply an enforcement action, such as moving the infected host's port to a quarantine VLAN or applying a restrictive Access Control List (ACL).
B. Policy Enforcer: Policy Enforcer orchestrates the response and communicates with Forescout; it does not communicate directly with the third-party switches for enforcement.
C. Juniper ATP Cloud: Juniper ATP Cloud is the threat detection service. It identifies threats and reports them to Policy Enforcer, but it does not perform network enforcement actions.
D. SRX Series device: The SRX Series device acts as a sensor to detect threats and can enforce policies at the network edge, but it does not manage or directly configure third-party access layer switches.
1. Juniper Networks Technical Documentation, Security Director: In the "Policy Enforcer Overview," the documentation states, "Policy Enforcer integrates with network access control (NAC) solutions, such as Forescout CounterACT, to extend threat remediation to third-party switches." This indicates that Policy Enforcer relies on the NAC solution for communication with third-party hardware.
Source: Juniper TechLibrary, Security Director Device Management, "Policy Enforcer Overview".
2. Juniper Networks Solution Brief, "Juniper Networks Connected Security with Forescout": This document explicitly details the workflow. "When a threat is detected, Policy Enforcer sends the infected host’s IP address to Forescout CounterACT. Forescout CounterACT can then take a variety of actions, including quarantining the device by communicating with the network switch or wireless controller to block the compromised endpoint."
Source: Juniper Networks, "Juniper Networks Connected Security with Forescout" Solution Brief, Page 2, "How It Works" section.
3. Juniper Networks Technical Documentation, Security Director: The workflow for integration is described as: "Policy Enforcer sends the infected host information to Forescout... Forescout then takes the configured action on the host, such as quarantining or blocking it." This confirms Forescout is the component taking the direct action on the network infrastructure.
Source: Juniper TechLibrary, Security Director Policy Enforcer Administration Guide, "Understanding Policy Enforcer Integration with Forescout".
Keep practicing
Take the free JN0-637 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other JN0-637 practice questions
- Question 3You want to enable transparent mode on your SRX series device. In this scenario, which th…
- Question 5You have deployed a new site as shown in the exhibit. Hosts in the 10.10.10.0/24 network …
- Question 6You configure two Ethernet interfaces on your SRX Series device as Layer 2 interfaces and…
- Question 8You have deployed an SRX Series device at your network edge to secure Internet-bound sess…
- Question 10You want to bypass IDP for traffic destined to social media sites using APBR, but it is n…
- Question 11You are using ADVPN to deploy a hub-and-spoke VPN to connect your enterprise sites. Which…
