JN0-637 practice question 3 of 25
You want to enable transparent mode on your SRX series device. In this scenario, which three actions should you perform? (Choose three.)
Full set: 115 questionsTo enable transparent mode on an SRX Series device, you must first change the device's forwarding mode from the default packet-based (Layer 3) mode to transparent-bridge (Layer 2) mode. This fundamental change requires a system reboot to take effect. Once the device is in transparent mode, the physical interfaces that will forward traffic must be configured for Layer 2 switching by setting their logical unit family to ethernet-switching. Finally, to apply security policies and allow traffic to pass through the device, these Layer 2 interfaces must be assigned to security zones, just as Layer 3 interfaces are in packet mode.
B. Install a Layer 2 feature license. Transparent mode is a fundamental operational mode of the SRX platform and does not require a separate feature license to be installed.
D. Ensure that no IRB interfaces are configured on the device. An Integrated Routing and Bridging (IRB) interface can be configured in transparent mode to provide a Layer 3 management interface for the SRX, so its absence is not a prerequisite.
1. Juniper Networks TechLibrary, Junos OS Security Configuration Guide, "Understanding Transparent Mode Security"
Reference for C: "To enable Layer 2 transparent mode, you must reboot the device after you set the packet-based option under the [edit security forwarding-options family mpls] hierarchy." This section explicitly states the requirement for a reboot after changing the mode.
Reference for A & E: The guide explains, "In transparent mode, you configure Layer 2 logical interfaces... You then configure security zones and attach these Layer 2 interfaces to the zones." This confirms the need to configure interfaces for Layer 2 (ethernet-switching) and place them in zones.
2. Juniper Networks TechLibrary, "Example: Configuring the SRX Series Device in a Transparent Mode"
Reference for C: In the configuration steps, after setting the mode with set security forwarding-options family mpls mode transparent-bridge, the document notes: "You must reboot the device for the configuration to take effect."
Reference for A: Step 3 of the example shows the configuration of interfaces using set interfaces ge-0/0/2 unit 0 family ethernet-switching.
Reference for E: Step 4 demonstrates assigning the configured Layer 2 interfaces to security zones, for example: set security zones security-zone trust interfaces ge-0/0/2.0.
Keep practicing
Take the free JN0-637 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other JN0-637 practice questions
- Question 5You have deployed a new site as shown in the exhibit. Hosts in the 10.10.10.0/24 network …
- Question 6You configure two Ethernet interfaces on your SRX Series device as Layer 2 interfaces and…
- Question 8You have deployed an SRX Series device at your network edge to secure Internet-bound sess…
- Question 9You have deployed automated threat mitigation using Security Director with Policy Enforce…
- Question 10You want to bypass IDP for traffic destined to social media sites using APBR, but it is n…
- Question 11You are using ADVPN to deploy a hub-and-spoke VPN to connect your enterprise sites. Which…
