JN0-637 practice question 10 of 25
You want to bypass IDP for traffic destined to social media sites using APBR, but it is not working and IDP is dropping the session. What are two reasons for this problem? (Choose two.)
Full set: 115 questionsAdvanced Policy-Based Routing (APBR) identifies applications midstream, not on the first packet. Initially, a session is created based on a standard security policy lookup. This initial policy may have IDP enabled. Once the application is identified, the session must be re-evaluated and reclassified to match the specific APBR rule. If this midstream reclassification fails (A), the session remains under the control of the initial security policy, and IDP will process the traffic. Alternatively, if the session reclassifies correctly but the APBR rule itself lacks the application-services bypass (or no-idp) configuration (C), the rule will only dictate routing. The session will still be subject to the security services, including IDP, defined in the matching security policy.
B. This is imprecise. The correct configuration is to bypass "application-services" in general or no-idp specifically, not a generic "IDP disable" setting on the rule.
D. This is factually incorrect. APBR relies on application identification, which requires inspecting several packets (deep packet inspection) and cannot be done on the first packet alone.
1. Juniper Networks TechLibrary, Security Director: Advanced Policy-Based Routing Overview. This document explains the APBR process: "When a session is created, it first matches the security policy... After the application is identified, the session is re-evaluated for APBR policy lookup. If an APBR policy is matched, the session is closed and a new session is created with the new route." This supports the concept of midstream reclassification (A).
2. Juniper Networks TechLibrary, Junos OS 23.4: [set security advance-policy-based-routing profile rule then] application-services. This configuration guide shows the application-services statement within an APBR rule. It states that this option allows you to "Enable or disable application services for the traffic." Omitting this or not setting it to bypass/no-idp would cause services to be applied, supporting (C).
3. Juniper Networks TechLibrary, Junos OS 23.4: Understanding Unified Policies in SRX Series Devices. This document clarifies the multi-stage lookup process: "The first packet of a flow is used for a policy lookup. At this stage, the application is not yet known... After a few packets, the application is identified. The device performs a second policy lookup with the identified application." This directly refutes option (D) and supports the reclassification mechanism described in (A).
Keep practicing
Take the free JN0-637 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other JN0-637 practice questions
- Question 3You want to enable transparent mode on your SRX series device. In this scenario, which th…
- Question 5You have deployed a new site as shown in the exhibit. Hosts in the 10.10.10.0/24 network …
- Question 6You configure two Ethernet interfaces on your SRX Series device as Layer 2 interfaces and…
- Question 8You have deployed an SRX Series device at your network edge to secure Internet-bound sess…
- Question 9You have deployed automated threat mitigation using Security Director with Policy Enforce…
- Question 11You are using ADVPN to deploy a hub-and-spoke VPN to connect your enterprise sites. Which…
