NS0-184 practice question 3 of 15
On which type of network interfaces are the cluster interconnect LIFs created?
Full set: 60 questionsFor redundancy and high availability, cluster interconnect LIFs must be created on an interface group (ifgrp). An ifgrp is a logical grouping of two or more physical network ports, providing link aggregation and failover capabilities. This ensures that the critical cluster communication is maintained even if a single physical port, cable, or switch port fails. Using a single physical port is not a recommended practice for production clusters as it creates a single point of failure.
A. Cluster interconnect is an Ethernet-based network and cannot be created on FC or FCoE ports, which are used for SAN block protocols.
C. Cluster interconnect ports and their associated LIFs must be dedicated to cluster traffic and cannot be shared with other data or management LIFs.
D. While technically possible in a non-production or single-switch setup, creating the LIF on a single physical port is not the best practice and lacks the required redundancy for a production cluster.
1. NetApp ONTAP Documentation, ontap-networking-config - Concepts for cluster and management network configuration. "For redundancy, the cluster network is configured on an interface group (ifgrp) of at least two physical ports from each node."
2. NetApp Technical Report TR-4684, "NetApp ONTAP Cluster Network and Management Network Best Practices," Section 3.1 Cluster Interconnect Network. "The cluster interconnect network must be configured on an interface group (ifgrp) of at least two physical ports from each node."
Keep practicing
Take the free NS0-184 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other NS0-184 practice questions
- Question 2Which command would be used to measure the throughput and latency of traffic between node…
- Question 4After adding two nodes to an FC-enabled cluster, the storage administrator wants to ensur…
- Question 5You have a 2-node FAS8300 ONTAP 9.8 cluster that serves SMB shares. You are configuring i…
- Question 7You are using Broadcom BES-53248 switches for a cluster interconnect in a base configurat…
- Question 8You have a 4-node ONTAP 9.8 cluster with a FAS8700 HA pair that serves iSCSI LUNs. You ar…
- Question 9You have completed a base installation and system registration of an AFF A250 system, but…
