NS0-184 practice question 9 of 15
You have completed a base installation and system registration of an AFF A250 system, but you notice that you have one failed drive. Neither “un-failing” nor reseating the drive helped to repair it. You must ensure proper replacement of the failed drive. In this scenario, which two actions should you take? (Choose two.)
Full set: 60 questionsWhen a drive fails in a new system and basic troubleshooting (reseating) does not resolve the issue, the correct procedure is to engage NetApp Support. The customer should open a technical case (A) to initiate the Return Merchandise Authorization (RMA) process for a replacement part. To facilitate a quick resolution, NetApp Support will require diagnostic data to confirm the hardware failure. Running a data collection tool like Active IQ OneCollect, or ensuring a recent AutoSupport has been sent, is a necessary step. Option C, while naming Config Advisor, represents this essential action of collecting system logs for the support case.
B. Ask the customer for a drive with the same capacity and replace it: This is incorrect and unsupported. NetApp drives have specific firmware and are not interchangeable with third-party or generic drives, which could lead to data corruption or system instability.
D. Power off the system until the drive has been replaced: This is incorrect. ONTAP systems are designed with RAID protection to be highly available and can sustain one or more drive failures without an outage. Powering off causes unnecessary downtime.
1. NetApp, "ONTAP 9.8 System Administration," Section: "Disk and aggregate management," Subsection: "Overview of replacing a failed disk." The procedure outlines verifying the failure and then following hardware replacement documentation, which involves support.
2. NetApp Active IQ Documentation, "Active IQ OneCollect." This describes the tool's function to "collect content from your NetApp products for troubleshooting, analysis, and archiving." This is the type of data needed for a support case.
3. NetApp Support, "How to open a case." The standard support process requires opening a case for hardware failures to receive a replacement part under a valid support contract.
Keep practicing
Take the free NS0-184 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other NS0-184 practice questions
- Question 2Which command would be used to measure the throughput and latency of traffic between node…
- Question 3On which type of network interfaces are the cluster interconnect LIFs created?
- Question 4After adding two nodes to an FC-enabled cluster, the storage administrator wants to ensur…
- Question 5You have a 2-node FAS8300 ONTAP 9.8 cluster that serves SMB shares. You are configuring i…
- Question 7You are using Broadcom BES-53248 switches for a cluster interconnect in a base configurat…
- Question 8You have a 4-node ONTAP 9.8 cluster with a FAS8700 HA pair that serves iSCSI LUNs. You ar…
