NS0-184 practice question 5 of 15
You have a 2-node FAS8300 ONTAP 9.8 cluster that serves SMB shares. You are configuring interface groups for higher performance and resiliency. Which two NetApp best practices should you follow to satisfy these performance and resiliency requirements? (Choose two.)
Full set: 60 questionsWhen creating an interface group (ifgroup) for both performance and resiliency, NetApp best practices dictate two main principles. For resiliency, member ports should be distributed across different physical Network Interface Cards (NICs) or onboard port groups. This ensures that the failure of a single NIC does not cause the entire ifgroup to fail. For performance and stability, all member ports in the ifgroup should have identical characteristics, which includes using ports with the same speed, type, and underlying chipset.
B. Using ports from the same NIC creates a single point of failure; if that NIC fails, the entire interface group goes down, violating the resiliency requirement.
C. Using ports with different chipsets can lead to inconsistent performance, compatibility issues, and unpredictable behavior within the link aggregation group.
1. NetApp, TR-4067: LACP (802.3ad) and Cisco vPC Best Practices with NetApp ONTAP, Section 3.1.1. "For maximum resiliency, NetApp recommends that ports from different network interface cards (NICs) be used to create the ifgroup."
2. NetApp ONTAP 9 Documentation, Network management guide, section "Considerations for creating interface groups". The guide states, "For best resiliency, you should use ports from different NICs in the same node" and "All ports in an interface group must have the same speed and be of the same port type (for example, all Ethernet)." This implies using similar hardware (chipsets).
3. NetApp ONTAP 9 Documentation, Networking, section "Interface group configuration". "To provide failover protection in the event of a network card failure, you can create an interface group with ports that are on different network cards."
Keep practicing
Take the free NS0-184 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other NS0-184 practice questions
- Question 2Which command would be used to measure the throughput and latency of traffic between node…
- Question 3On which type of network interfaces are the cluster interconnect LIFs created?
- Question 4After adding two nodes to an FC-enabled cluster, the storage administrator wants to ensur…
- Question 7You are using Broadcom BES-53248 switches for a cluster interconnect in a base configurat…
- Question 8You have a 4-node ONTAP 9.8 cluster with a FAS8700 HA pair that serves iSCSI LUNs. You ar…
- Question 9You have completed a base installation and system registration of an AFF A250 system, but…
